Question about Stanley Air Tools & Compressors
...gun , model N95RHN blows air threw the trigger and won't fire. prolly clogged, buy a rebuild kit and use it making sure all parts are totally clean before reassembly. in the future be sure to drain ...
...trigger is pressed. no nail fires help|| on 2 years od| check to be sure that there is not part of a nail jammed in the gun. If not, use some WD-40 or other lube to lubricate the path of the nails. ...
...Trigger feels floppy. Lots of air coming out of exhaust at top of gun over piston. You need my rebuild kit. AirNailerParts Nailer Parts Corey is correct - you need an ORK11 kit. Take your time, clean ...
Question about RTO Air Tools & Compressors
...gun thoroughly and personally think it may be something to do with the circuit board or the head switch assembly not allowing the spark plug to spark? Some expert advice would be appreciated. My ...
Question about Air Tools & Compressors
...gun assembled but gas cell REMOVED look at LED on handle, with battery fitted LED will flash. Now press it against work piece, LED will stay lit whilst still watching LED press trigger. LED should ...
...Gun. It was leaking air. I replaced the O rings and trigger valve with bostitch kit parts. The leak has stopped, but it no longer gets enough pressure to shoot a nail. Have checked and re-checked all ...
...gun is blowing out air from the top when I pull the trigger.I opened it up and the valve was stuck open so I popped it back down.Its colder now so should I be lubercating it more often or is there ...
Question about Air Tools & Compressors
...trigger pin is pressed in/out. What did I do wrong, as nothing looks out of place or defective. This gun is immaculately clean inside and I have always used an auto oiler when using it. Any help will ...
Question about RTO Air Tools & Compressors
...trigger mechanism. I made sure the wire was fully seated and applied some glue to the point where the insulated wire leaves the sealed unit. Once reassembled, the gun fired like a charm and has not ...
Question about Stanley Air Tools & Compressors
...trigger valve and o-ring kit will give you a like new gun. Just remember to replace all available o-rings in the kit, lightly grease all of them as you reassemble the gun and use pneumatic oil ...
366 questions posted
Usually answered in minutes!
4 Questions
9 Questions