RTO PasLode 900420 Impulse Framing Nailer  "finishing gun firing" Questions

...finishing nails & connected the nailer to my compressor. I followed the minimal instructions & pulled the trigger (sequential) but it did not fire. There was no nail, no air, no nothing! I repeated ...

...to access trigger parts. Part # LB5005 (firing valve) is the part that fails the most on your gun but failure of this part leaks air out of top. You should keep a spare firing valve just in case. ...

GUN DOES NOT FIRE FOR SEVERAL ATTEMPTS--even though gun is pressed firm against work---just had unit serviced and trigger valve replaced-----any suggestions? thanks joel Remove nails and remove ...

NEW BRAD NAILER ONCE LOADED WILL NOT WORK TOOK THE COMPRESSER AND GUN RIGHT OUT OF THE BOX HOOKED UP EVERYTHING PUT BRADS IN GUN PUSHED THE TRIGGER AND NOTHING IS THERE A SAFTY ON THE FRONT OF GUN ...

how do I get my finish nail gun to fire? new gas cartridge, nails, fully charged battery. the gun will omit gas and the fan will operate but won't fire. brand new out of the box! don't have any of ...

My finish nail guns, 16 ga won't fire. I have three paslode nail guns that all have the same problem, they all make the noise but won't fire the nail. Help, I don't want to put up casing the old ...

nail gun double fires My 15 guage finish nailer some times fires twice with one trigger pull. It has a full sequential fireing system with no bump fire option. It is not shooting two nails at once, ...

Dewalt cordless nail gun fires but doesn't seem to feed the nails very well, alot of misfires. Try another brand of nails -- maybe your gun doesn't like those. Also, blow any dirt out of the nail ...

...gun the firing valve is inside of the cap . first check to see if the gun has enough oil( unless its an oil less gun) if its dry then grease or oil all of the orings, if this dose not work check to ...

the pin on my Dewalt dc616 cordless finish nail gun is ceasing up. How can i lubricate it? can i spray silicon into the nose of the gun? Hello, W/D here. The better way is to disconnect the air line ...