Question about Welding Tools
...speed and voltage settings as one affects the other I am guessing you are as new to the welder as it is to you. I suggest you read the manual carefully and ensure the machine settings (torch tip and ...
Question about Bobcat Welding Tools
...welder generator not stay at an idle when switched to low idle? The unit may need recalibrating the idle/run setting. Instructions found in manual at 8-6 (subaru engine) and 9-5 (kohler). Idle speed ...
...speed. The welder might have a chart for these settings in the manual or inside cover. If the wire feeds too fast, it will push the probe around and you will feel pressure as the wire feeds out. If ...
...speed setting should i use to weld 1/16 square stock without burn thru? you should run power between 160-180 to get a godd weld with out burning your work proper heat settings for the size plates you ...
...welder 185n pro series mig mag gas gasless purchased from Edison's it has a switch on it titled 1 and 2 they have an on line manual that is useless it simply says switch 1 and 2 but doesn't explain ...
Question about Welding Tools
...speed. It may be a binding linkage, it may be bypassed by a previous owner.Chances are, as the idle relay is controlled through a load sensor on the control board and it may simply be a wire is ...
...mig 300,lincoln,used.i did not get a operators manual with it.i do not uderstand how to adjust speed,wire.any info would be helpfull,thankyou. You can find your operator's manual either
...not tripped (Looks like a "push to reset") - Rotate knob to desired heat setting. - Set wire feed speed to desired setting. - Press power button to turn machine on. - With your helmet on, Hold wire ...
...Welder Manual neglects to describe the operational settings and polarity for gas & Non-gas use. I am having difficulty in running a weld even with minimum wire feed speed using gasless wire on ...
I have a Hobart Handler 120. New liner. It will only feed with the speed dial above 8. it does not feed at anything lower, no matter what voltage is set. Hi: Looks like your speed wire control went ...
5 questions posted
Usually answered in minutes!
39 Questions