Precor C954i Commercial Treadmill "micro switch replacement" Questions

. so we can not increase the speed at all. All other buttons seem to work, including incline and decline arrow buttons. The micro switch is probably bad, the button (micro switch) needs to be replaced

on my Precor 956 i the Stop Key prompt appears There is a micro switch under the red "Stop" button. The switch is stuck and needs to be replaced.

...work and the other buttons will only work occassionally. we have a precour 9.21s hi check the push button (micro switch) for enter. may be it faulty. if found faulty replace it. its a cheaper one. ...

...switch contacts but it didn't work. I also didn't see any overheated/melted/burned components or blown capacitors on either the lower motor circuit board or the upper console circuit board. I hate to ...

micro switch on control pane is faulty. if so you have to push it harder than normal. Try to replace the switches in control panel. If you wish to get some details; check the site linked here. Pull up

...micro switch and reassemble.replace spring if damaged or rusted also. iv had similar problems, but it was when i had a lot of electricity being used at the house - every time i switched it on after a ...

...a console, or the safety key switch might be defective. To check it, the console must be removed and the console base removed. Inspect and test the micro switch. The console is no longer

...micro switch with an original one otherwise open, clean and reassemble all. I need a a power lead for life fitness 9100hr treadmill As said in the other post clean around and under button making sure ...

...you must go back to the driver IC and verify that is good, and if good you need to go back to the micro to verify it is sane ;o) You can find repairs and refurbished motor control boards by

...console runs about $300 but I am almost positive its the small circuit board that contains all the micro switches. Is there a place to buy the individual boards? Just replace the micro switches. You ...