Acer Gateway One ZX6980-UR308 All-In-One Desktop PC with Intel Pentium "factory jumper settings" Questions

...If you can't find a CMOS jumper, try unplugging your computer and removing the battery on your motherboard for a few minutes. When you turn it back on, your CMOS should reset to factory

...master setting. The jumper is in the leftmost position, when removed the disk is set for a slave. The next position is for cable select, closed on, open off. The other positions are for factory

...jumper to clear bios/cmos No need for the jumpers just take out the little battery and leave it out for anywhere from 30 seconds to 5 minutes and this will clear CMOS and return BIOS to factory ...

...factory settings in dell optiplex gx520 Hi, The BIOS password may be cleared from a Dell Optiplex by removing the password jumper (PSWD) from the motherboard. Can click the link below to see how its ...

...factory default is by shorting the CMOS reset jumper located in your motherboard, usually it?s the closest jumper to the battery or the CMOS chip. This does not require any password, actually this is ...

...FACTORY SETTINGS.LOOK AT THE JUMPERS ON THE OLD HARD DRIVE THAT YOU ARE REPLACING AND SET THEM EXACTLY AS THAT DRIVE.CHECK ALL CONNECTORS AND RIBBONS FOR SOLID CONNECTIONS.SOMETIMES,THE PINS INSIDE ...

...factory settings? You need to use the clear CMOS jumper on the motherboard.There is a jumper that you short for a few seconds then remove. You can also pull the computer battery for about a minute ...

...factory defaults pin the jumper on pins 2 and 3 for 2-3 seconds. (Machine OFF power unplugged!! Before you do this! You have been warned) After 2-3 seconds put the jumper back on pins 1 and 2. Plug ...

...FACTORY RESTORE MY SYSTEM IF THE SYSTEM IS LOCKED WITH A PASSWORD The simplest and quickest way is to take the Cmos battery out. Wait 10-15 min. Then re-insert this should put the system back to ...

...open the cover of the cabinet now examine it , there is a cell, near to it is a jumper put it on to 2-3 position, or simply take out the cell start the pc the default factory setting will be ...