...door and, while pulling out on latch handle, slip the ring over the latch handle and get it into approximate position. Let go of latch (it snaps into "closed" position) and adjust ring so it doesn't ...
Question about Avanti Washing Machines
...the machine useless. You have to replace the door latch mechanism. Go to attached site for parts Search Over 2 1 Million Appliance Parts Probably a door latch adjustment. Worst case a new
...door, you may be avail to move , adjust or bent the mechanism to make it work, if not , 2 thing you can do, replace it, it is only 2 screws or by pass the switch, no recommended. but it works. to by ...
...or broken wires, test by continuity VOM .2) adjust the Door vs switch very well for propely closed, and test the closed switch.3) see if the color are missing and put in the WRON terminal.God bless ...
...door latch and that *usually* fixes the problem for that wash load. Other times I get the infuriating F 11 error code and you can hear a relay in the MCU click a few times 5 or 10 seconds apart and ...
...Door latch does not lock. I have adjusted the latch mechanism on the door and made sure that the door closure switch is fully depressed. Washer will click as if trying to close the latch. Tried ...
...the handle again to retract the latch and inspect the mark made by the jelly. Move the strike plate to accommodate for the overlap of the latch. Try closing the door again. Adjust as
Door Rattles How would I adjust the Latch on my machine to pull the door in tighter. Get the rubber door boot loose, reach inside to where the door latch is and remove the 2 screws holding it in. Then
...2 screws or small bolts you will loosen to slide the lever or the latch plate to adjust so the door closes tighter. 4. If ok, then the water level sensor will have to be replaced by a qualified
63 questions posted
Usually answered in minutes!
243 Questions
129 Questions
64 Questions
55 Questions
59 Questions