Electrolux AWW1417 Front Load Washer / Dryer "water valve open" Questions

...water valve is bad..Replace.Sometimes the vales can stick open a little it is caused by buildup inside valves from minerals and other items in water....Note make sure if you replace valve that you ...

water valve is in open?if is open remove the hose connecting to water valve and clean the screen filter,is is clean check the water valve if is running,try to open again the unit with normal operation

...water valve and open up one working valve to release the pressure then take a bucket and place it under the valve to replace now screw off the old valve. remeber hwo it was fitted. now take some of ...

...water valve opening to let the hot water enter for rinse cycle. This means that the hot water and cold water inlet valves are not stuck. I cannot figure out why the cold water valve opens only during ...

...water valve one at a time and let the water flow into the bucket. If the water flows freely then the water supply hoses are not clogged. This is to test to be sure the water is flowing properly from ...

...water flows from the source to the washer; then a Valve is not opening into the washer. The valve is controlled by the washers circuit board. This solenoid is electrically activated upon command, and ...

...water valve on the machine but still not valve not opening to let cold water in so it will rinse Check Water is okay at the Valve, next clean the valve filter .Is still no joy fit a new valve /Check ...

water fill valve - The water fill valve is a mechanical and electrical part, the coils on the valve need electricity to mechanically open the valve to allow the water to flow into the washer....myth..

water fill valve - The water fill valve is a mechanical and electrical part, the coils on the valve need electricity to mechanically open the valve to allow the water to flow into the washer....myth..

...valve for hot water. There is a place (most likely at the valves where pipes meet washer) where electrical connection e.g due 2rust, has been lost. Thus the valves r not being opened by the