...water that can remain in the wash tub and drain hose lines (this is normal). If you pull the drain hose from the standpipe at the wall and pull a vacuum on it with a shop vac, this will make clean up ...
Question about Kenmore Elite Washing Machines
...water remains in the wash tub under the wash basket (stainless steel tub), and resides in the drain line and drain pump. That's why it is important to keep the door slightly open when not in use to ...
...water remains in the tub at end of cycle I had a similar problem. The pannel under the door can be removed by 3 screws. After that if you look there should be a water pump there (it will have a drain ...
Question about Kenmore Elite Washing Machines
...water left inside the wash tub under the wash basket. This is why it is important to leave the door ajar when not in use so this water does not become sour. Thanks for using FixYa - a 4 THUMBS rating ...
Question about Kenmore Elite Washing Machines
...remain wet...spin seems to be slow There is a water pump in the machine which pumps the water out of the outer tub and into the drain, after the wash and rinse cycles. It is possible that this pump ...
Question about Kenmore Elite Washing Machines
...water left inside the wash tub under the wash basket. This is why it is important to leave the door ajar when not in use so this water does not become sour. Thanks for using FixYa - a 4 THUMBS rating ...
Question about Kenmore Elite Washing Machines
water out. If you look under the lid at the back there is the end of a hose in mid air. The hole it goes in looks like the hose just stuck in and was held in place with gasket maker. Could this be the
Question about Kenmore Elite Washing Machines
water out because its' motor gets hot and shuts down or because of a problem in the control mechanism which manages the the starting and run time of the pump. First, I would unplug the washer from the
Question about Kenmore Elite Washing Machines
water out because its' motor gets hot and shuts down or because of a problem in the control mechanism which manages the the starting and run time of the pump. First, I would unplug the washer from the
Question about Kenmore Elite Washing Machines
...water....you will also need a 7/16" nut driver or socket to take the three screws from the pump...one wiring harness plugs in under a flip up hood. Remove two clamps, the harness and screws. Remove ...
1,394 questions posted
Usually answered in minutes!
3,839 Questions
0 Questions
69 Questions
45 Questions
20 Questions