Kenmore Elite Oasis 27052 Top Load Washer "kenmor shows f2" Questions

...F2 shows up again.What about the pump? Can it be that the pump doesn't make enough pressure or where are the sensors located?What can it be.Thanks for help! Mike If the drain time exceeds 8 minutes, ...

...shows F2 during the wash cycle. Taken the tub drain pump and hose apart, no obstruction found. Replaced pressure switch no change. Ran diagnostics with no problems found. go back to drain pump.. pull ...

shows F2 but I find nothing in the manual about this code. According to the Whirlpool Cabrio (Sears Oasis) manual, this code indicates a "stuck key" Keypad/User Interface Failure F then 2 flashes when

...shows an error code 5ud And the code is!? Gee I hate when that happens! OK look at these: F1--Water supply/low water fill. o 1. Check water supply to machine. o 2. Replace water inlet valve. • ...

F2 error code I'm getting a F2 error code on my Kenmore Elite Oasis top loading washing machine. What does it mean? I am also have problems with this Oasis model with Serial # CU33 that started acting

...shows an f2 code. any suggestions "F02" is a Long Drain error. If the drain time exceeds 8 minutes this error code will be displayed. In addition, a "SUDS" error may also be generated as a secondary ...

...to FixYa. This is a general remedy for most Whirlpool made front-load machines, such as Whirlpool, Kenmore, Maytag, Amana etc. The "Sd" or "F2" is the same as F21 on most Whirlpool washer's and ...

Kenmore elite smart Wash quiet pak 9 with an f2 code Sometimes I get this code, looking for the answer I had the same or similar problem, after troubleshooting with the above post to no avail I ...

shows error code PF. At times it will not come on at all. At times it beeps erratically. Washer is a Kenmore Elite top load The PF indicates a power failure. The range experienced a loss of electrical

f2 error Hello, Welcome to FixYa. The "F2" on your model of washer indicates the machine has detected a fault or obstruction in the drain process. Chances are the pump itself is being obstructed by ...