Kenmore Elite Oasis 27052 Top Load Washer "check motor rotation alarm" Questions

...motor rotation. Check to see if the basket spins freely. If not, you could have an item caught between the outer tub and the inner spin basket. A toy or other item underneath the washer could also ...

...check the motor harness, connectors and motor for discontinuity. This can be done by taking a resistance measurement between phases of the motor harness at the Motor Controller module end. Nominal ...

motor. 6. Check the drive motor for powered rotations. Phil's comments---> If you just set the machine up be sure the shipping bolts have been removed, this is the most common reason for F06. Other

...check, the Motor Control Module has found that the bowl is not engaged even though the pressure sensor indicates that the bowl is empty. The Motor Control Module continues to check for 2 minutes, ...

...motor. 7. Check the drive motor for powered rotations. 8. Check that the serial harness at the MCU is not mounted upside down. The wires should be to the left when facing the MCU connectors. Replace ...

alarm sounds and then it ends. I opened the unit and the belt is fine, drum spins manualy and/or if I spin it via the fan attached to the motor. any clues into the issue. Oh, lastly, ran it last night

Check the service manual at page 12 & 13 and you will see a component (part 427) which has two little cords. Disconnect and reconnect this plug two or three times in order the pins inside the plug

...check motor brushes, drive belt, tachometer or tachometer magnet, motor relay or PCB (TRIAC motor control). E40: Water level too low during heating cycle - check supply or inlet valve, or float level ...

check the following: C:00 - Door Lock C:01 - Flow Meter, Cold Water Solenoid C:02 - Dispenser Motor, Dispenser Contacts C:03 - Hot Water Inlet Valve C:04 - Motor rotates CW at wash speed C:05 - Heater