2008 Saab 9-5 "line bolt alternator" Questions

...bolt through the upper mounting. Do not tighten. Connect the cable and the connector. Install the lower bolts for the alternator (upper bolts for the compressor). With AC, tighten the 2 lower bolts ...

...screwdriver to pry alternator off bracket, it pinches on when the pivot bolt is tightened. Drop alternator out bottom of engine bay; helps to unbolt or bend transmission cooler lines out of the

...bolt in reverse order of their removal with old alternator. Slide the belt back onto the pulley system with the new alternator in place. Reinsert the alternator nut and tighten it to adjust the belt ...

...the smaller charge power line, and then remove the case to ground line. after that, remove the underside mount bolt, and the alternator should drop right out. Very easy job to do, maybe one

...BOLT.REMOVE ALTERNATOR UPPER MOUNTING BOLT.REMOVE RIGHT SPLASH SHIELD. REMOVE DRIVE BELT FROM THE ALTERNATOR PULLEY.REMOVE AC COMPRESSOR AND SUPPORT IT ASIDE LEAVING THE REFRIGERANT LINES ...

...the alternator up and down as you wiggle the bolt they are a tight fit and if the alternator is line up 100% they wont slide out easily do the same when reinstalling hope this helps and good ...

...or take a picture.remove drive belt remove 2 bracket to alternator bolts on OHV models,2 bolts & 1 stud bolt on OHC. reassemble in reverse order. liquid paper also good for lining belt back

...for the alternator so I was looking for a diagram on line. alternator has two bolts only if it come to be a tensioner, ok. the bolts is at the bottom and the other one is to adjust the tension, ...

...line up with to rear bolthole on some alternator mounts there is a bush in the hole (Engine part) that can be moved in or out to allow the alternator to fit in easily. You will see it as aprotrusion ...

...alternator pivot bolt and spacer and adjustment nut and bolt,when you remove alternator you have to angle it out through bracket by the AC COMPRESSOR. YOU DONT HAVE TO DISCONNECT ANY AC LINES OR ...