2009 Honda CR-V "remove rear bumper" Questions

...remove the rear splash guards(the plastic pieces located near the tires) After that, it should be about 6 bolts/clips and they are located in plain view just standing facing the bumper. Then the ...

...remove light bulb cover of rear license plate light you have to go under the bumper and and look behind then look for the back of the lightbalb connection. if you see that. pull on it carefully. if ...

rear on right side When driving on rough street I hear an intermittent rattling sound and cannot find the cause. Make sure all loose items in car and trunk are secured or removed. try again after that

...remove a rear bumper cover on a 2007 nissan altima Rear Bumper: Service and Repair REAR BUMPER Removal and Installation REMOVAL 1. Remove the LH and RH rear combination lamps. 2. Remove both the rear ...

...remove the rear bumper on a 2005 Kia Sedona 1.Remove rear combination light assembly.A.Remove two mounting screws. B.Disconnect electrical connector from rear side of light assembly. 2.Remove bumper ...

Remove rear combination light assembly. A. Remove two mounting screws. B. Disconnect electrical connector from rear side of light assembly. 2. Remove bumper assembly. A. Remove four fasteners and four

...remove rear bumper 1999 blazer Hi there:Check this Removal Procedure...1. Remove the rear bumper step pads. 2. Remove the license plate lamps. 3. Remove the nuts and the bolts that retain the rear ...

...remove rear bumper on ur tucson. Open the trunk of your vehicle. Unscrew all the screws on the inside plastic trim that covers your bumper to trunk connection. Pry the plastic piece out with a ...

...remove the rear wheels. Using Torx Bits, remove the inner rear wheel well lining. Get behind the rear wheel well and loosen the bolts holding the bumper brackets on. They're pretty difficult to find ...

...rear. 4. Remove 2 phillips head screws in the wheel well rear lip. 5. Remove 4 pop-up plastic retainers in liftgate area. Use two screw drivers to lift the head and then pull the entire retainer ...