A blown fuse. 2. A bad fan switch. 3. A bad connection/short somewhere between the switch and the fan motor. 4. A bad fan motor. This is the order that I would troubleshoot from. I hope this helps you
...3. Remove the 5 screws mounting the A/C-heater blower motor housing to the rear HVAC unit (one mounting screw located on evaporator cover). 4. Twist the blower motor out of scroll housing. 5. ...
Question about Chrysler Town and Country
...motor up fast, when you 1st start it. Maybe stuck closed. It happens. My secret weapon is to go to the library, request a copy of 'Mitchels Repair Manuals' for your model, and copy the ...
Question about Chrysler Town and Country
...3 motor that has a 3 prong crank sensor, can you put the crank pulley and sensor off of a motor that has a 2 prong sensor? It is a 2005 Mazda 3 with a 2.3 motor. The new motor has no pulse at ...
...3 wiper motor (module assembly) retaining bolts and remove the module assembly from the vehicle. 7. Remove the wiper linkage retaining bolt and remove the linkage from the wiper motor. 8. Remove 3 ...
Question about Pontiac Cars & Trucks
...3) that secure the blower motor to the vehicle. Pull the blower motor from the vehicle. Step 4: Disconnect the wiring harness (1) mounted just to the LEFT of the resistor. Step 5: Loosen and remove ...
...3 class failures on motors (all) 1: The motor don;'t get full 12vdc power (use a voltmeter) 2; the motor is weak, they sure can be , like bad commutator segments and open windings off a segment. etc. ...
...3) Check motor wiring harness for short between high and low speed circuits. Connect a voltmeter or test lamp to motor ground strap. Set wiper/washer switch to LOW position. Connect other lead of ...
Question about Chrysler Town and Country
motor is 1-2-3 and the right side is 4-5-6 this is looking at the motor standing in front of it and then the coil order is from left to right 1-2-3 back side, front side 5-6-4 the firing order is1-4-2
...remove the heater unit. Then remove the top of the heater motor and then the motor is held in by 3 screws.Remove these 3 screws to remove the motor.Let me know if you need more ...
229 questions posted
Usually answered in minutes!
133 Questions
79 Questions
35 Questions
30 Questions
22 Questions