Konica Minolta Magicolor 4690MF Multifunction Laser Printer "overheating fuser" Questions

...overheating but just due to the heat of the fuser and time. The fuser can not overheat as it is protected by thermal fuses that would blow if the fuser became too hot. These roller will deteriorate ...

i have a c920 lexmark with a fault code 920.000. my guess is that the fuserisnt heating up... based on the fact that its not getting hot... im guessing the fuser lamp has blown.... is there any other ...

...overheating in Kyocera printer The Thermistors in the fuser are not opening at the right temperature causing thermal runaway. Either rebuild the fuser and replace those parts. or replace the fuser ...

paper is getting crinkle up the two orange rolers are also wrinkled possiblt overheated???? If the paper if getting a fan fold and then jamming at the fuser unit, this would suggest a pick off finger ...

overheating getting far too hot, not picking up paper properly, part printing of page 1.call service. it's dangerous becouse too hot fuser section can make open fire. teristor in fuser damaged, or ...

Fuser error usually means that the heater element has blown, or is not functioning properly. The device will usually lock itself out to prevent any risk of overheating and causing a fire You will need

...fuser its worn, its probably overheating. I can suggest to take it out (in the back you will see 2 blue locks) for about half hour (turn the unit off before you are doing that) and put it back in. If ...

...can be damaged due to overheating Fuser thermistor or try to replace the entire fuser, clean electrical contacts which could cause malfunction of fuser.Este indicated a specialist to handle ...

error message-machine errror 6c Actualy the fuser has overheated and as a result probably has died. the best thing to do is to replace the fuser and power suply (probably there is a short in the fuser

...overheating? What is it and can it be replaced? UPDATE: I decided to pull the board out and the heatsink off. The processor is non replaceable (well not by me). I notice that there is a number of SMD ...