Question about HP LaserJet Office Equipment & Supplies
...side have 2 each laser which aim towards the middle of their respective chambers. There is a square reflective device on a motor shaft called a scanning mixer which when it spins directs the laser ...
alcohol The encoder on the end of the drum assembly is contaminated with the lubricant from the maintenance kit. You need to remove the right side cover, looking from the front. Look at the end of the
Question about HP LaserJet Office Equipment & Supplies
side so that it does not block the ribbon sensor.After pulling the ribbon away from the sensor, CLOSE THE PRINT HEAD.Hit Continue.It will now say CALIBRATING PLEASE WAITIt will
...side door. About midway down you will see an opening with a very fine wire in it. That is the wire responsible for transferring the ink from the drum to the paper. Dampen a Q-tip in some alcohol, and ...
side so that it does not block the ribbon sensor.After pulling the ribbon away from the sensor, CLOSE THE PRINT HEAD.Hit Continue.It will now say CALIBRATING PLEASE WAITIt will
Question about HP LaserJet Office Equipment & Supplies
...side of printer the error light flashes in sequences of 2 before a pause. print head screeches when it gets to the left and then it sticks first of all please turn off the unit....unplug the power ...
...side and I got the 5100 error. I turned off the printer and disconnected the power. I took a flash light and carefully inspected the clear ribbon. In the middle there was a bit of goop on the clear ...
Question about Fargo Office Equipment & Supplies
alcohol drip inside the printer's case. As an alternative method, use a can of compressed air and in a sweeping motion blow air into the printer from the card hopper working towards the card exit side
Question about HP LaserJet Office Equipment & Supplies
...side with a little alcohol to eliminate any contaminents that might be present to hinder connectivity. The last suggestion is to use a piece of paper with some rubbing alcohol on it and touch it to ...
alcohol) and a lint-free cloth or cotton swab, then reinstall the cartridge (clean the cartridge-side contacts as well). If it still does not work, could be the contact ribbon wire which got loose, or
82 questions posted
Usually answered in minutes!
1,429 Questions
1,001 Questions
724 Questions
663 Questions
593 Questions