Question about Panasonic Office Equipment & Supplies
...Intermediate Transfer Belt Length Detection Error Causes 1. Belt Initial Point Detection Sensor is defective. 2. Belt Initial Point Detection Sensor connector is disconnected. 3. EC PCB connector is ...
Question about Canon Office Equipment & Supplies
intermediate transfer belt is not detected within a specific period of time . The ITB HP sensor is faulty. Turn off the main power, and check the DC controller PCB and the ITB HP sensor; then, turn on
Question about Canon Office Equipment & Supplies
Intermediate Transfer Belt on a Canon IRC3100 How do I access the Intermediate Transfer Belt on a Canon IRC3100, error code 0002 Regards Justin" Your going to have to pull off the waste toner bottle, ...
Question about Office Equipment & Supplies
...Intermediate Transfer Belt Where the total print image is transferred to the belt then to the paper before being fused. ETB = Electrostatic Transfer Belt where the print image is transferred directly ...
Question about HP Office Equipment & Supplies
intermediate transfer belt(ITB). 2) Causes the toner to move from the surface of the ITB to the paper. In the CLJ 4700, there is an Electrostatic Transfer Belt instead of an Intermediate Transfer Belt
...disengagement roller is functioning. If not replace the sensor (SR17). 3. Run the primary transfer drive test in actuator drive mode. If not functioning replace the ITB (Intermediate transfer
Question about Kyocera Office Equipment & Supplies
...Intermediate transfer belt unit. 4. Confirm that the wiring connector is firmly connected and, if necessary, connect the connector all the way in. Transfer motor and Feed PWB 1 (YC13) Feed PWB 1(YC2) ...
Intermediate Transfer Belt (ITB) slides out from the right hand side. Open the manual feeder, pull out the right side transport, remove one screw and remove the cover behind the manual feed door, lift
...yep! e3-80 machine error has something to do with home position of the intermediate transfer belt. possibly the home position sensor is dirty or the belt itself, the home position guide is damaged.
...Intermediate Transfer Belt) may need changed. Try removing it first and rotating by hand. If it sticks, you are probably looking at a new unit. The link above is for the iRC3220 but Canon codes are ...
102 questions posted
Usually answered in minutes!
2,817 Questions
2,162 Questions
1,869 Questions
1,584 Questions
1,504 Questions