Question about Canon PIXMA Office Equipment & Supplies
...check the paper feed/paper tray..is something coming to it..the example paper-clipper come into it..so the paper can not be load on it. 2. the roller (it made by rubber).. if the rubber is getting ...
...check for any small paper bits stuck under the print head. Pull the paper out gently through the bottom end of the printer(if any). Close the top plastic lid. Power On the printer and check. If it ...
Question about Canon PIXMA Office Equipment & Supplies
...set correctly, if not you will get mis-fed sheets. check the tray is sat properly too or mis-feeds. Check paper size is correct in print properties too. Should be good then Try print. Regards
Question about Canon PIXMA Office Equipment & Supplies
...center check on the right side for any paper scraps caught over there. Check your paper too, plastic coated paper doesn't let the ink sink in and you can't print on a CD unless it has a paper
Question about Canon PIXMA Office Equipment & Supplies
...check all paper path inside printer, there is a paper door nearby power input. open-it and locate the sensors small plastic finger check for free mooving operation. normaly is one of three sensors ...
...paper. Check if there is any paper stuck on to the rollers, if so remove and clean. Check if there is any wearing of the rollers, alignment of the rollers. Finally use printer paper as thin paper ...
Question about Canon PIXMA Office Equipment & Supplies
...in it why is this happening ? You might try checking to make sure there that the paper is set in the tray correctly. Here are some other things to check: ...
Question about Canon PIXMA Office Equipment & Supplies
...the printer inside and out and its no paper no where in the printer and every time i try to print its says paper jam. check front and rear paper sensors. Maybe they damaged. Clean optical
...check for any paper jammed in the printer, switch it off and open all trays, sheet feeders, duplex unit to check for any paper. if paper was jammed previously and was torn, there might be a piece of ...
...paper tray. Check and verify that there is no paper or a piece of paper stuck in the roller or the belt. Remove all the paper from the paper tray and insert them again, do not fill the paper tray ...
874 questions posted
Usually answered in minutes!
2,244 Questions
2,149 Questions
1,862 Questions
1,594 Questions
1,302 Questions