...compressor wont engage, I put power direct to the clutch and it works. I also checked the high pressure switch, it has about 125lbs at idle. There is a relay on the compressor or next to the ...
Question about Dometic Heating & Cooling
...compressor tries to engage? Do you hear a "click" from AC unit when switched to cool? If none of that happens, then I'd start thinking thermostat, or compressor relay. Normally if it's a faulty ...
...compressor does not engage at all or turns on for 1-2 seconds and turns off again?if it does not engage at all it is a electrical problem(s). if it cycles on off then it has no freon and can try ...
...but when you turn to cool the a/c wont engage. Either a problem with thermostat, or perhaps faulty start relay for compressor. Do you hear a "click" or a slight "hum" or both when switch to
...compressor wont..anything I can do? This has three phase power Mitsubishi..Mr Slim If you have any experience in working with electrical systems, you can, but if not you should call a service ...
engage the power to the compressor or you have a bad capacitor that starts the compressor. Most units have a start and a run capacitor, but they are often in the same can. Sometimes you can ground out
...an insulated screwdriver or you finger push the contact in, the compressor and fan should run. Now if the relay is engage then it is more then likely the fan motor or capacitor. Hoped this helped ...
...compressor trys to to engage draws to much currant throwing breakers. has been suggested that the start capacitor could be faulty. I have a Mach III that the fan runs fine but when the compressor ...
113 questions posted
Usually answered in minutes!
1,056 Questions
416 Questions
195 Questions
147 Questions
138 Questions