...fix my Samsung t.v. I replaced the bulb, cleaned entire insides of t.v., checked if both fans were running, yes, checked for any corrosion or disconnects on boards/wires the best I could, I read ...
...hole on top and this is where the sensor is above. There is a small blue and white wire that plugs into it. If you pull the wire out and put a paper clip or wire in the coupling you will basically ...
...fix. this was a $50 purchase from a guy on craigslist. lucky find and thanks for the info for calling panasonic to get it fixed. I also had the big balls of color show up after about 5 years on my ...
...fix. I had the same green dot problem and I removed the front panel (no screws). In the center is a panel that has two screws. Remove them and pull the cover off. There you will find the projection ...
panel off and you see a heat sink which is sitting in the center of a aluminum sheet metal piece. Disconnect the wires which are attached to the circuit board behind the sheet metal. Then take off the
Question about Mitsubishi Televison & Video
fix for most of the DM boards in these sets. If you leave an e-mail address, I will send you the repair documents as well as the factory service manual so when you do repair your TV set and save about
...white boxes) on DM and FMT board, found 2 bad fuses on the FMT 1 being a 4Amp 1 being a 3.15Amp replaced with pico fuses (they work the same easier to solder on) put the tv back together and timer ...
...white fuse right bend the power plug. With a meter it read ok; about 8 inches deeper into the TV on that board was the resister next to two fuses. My 4 amp 125 volt fuse did not read on my meter. ...
97 questions posted
Usually answered in minutes!
37 Questions
1 Questions