Haier XQBM22-C Top Load Washer "tendancy" Questions

always unbalanced in the spin cycles the machine may need to be releveled, if it is not level the clothes will have a tendancy to go to the low side and thereby causing the unbalanced condition

...been disconnected from what allows it to operate. The problem is likely the timer. Your model has a tendancy to break off the tabs that hold the timer in position. To check this you will need to ...

...to the bottom of the drum. This is to stop it from bouncing around as well. these also have a tendancy to either snap their fixings (Bolts) or split and fall off. In either sutuation it should ...

...washer also check pump motor is clear or in my house my wifes under wires from here bra;s have a tendancy of comming through the pipes haha hope this helps ...

...the drum as it turns and spins. Make sure they are all intact and mounted to the drum (they have a tendancy, especially after having been run in an excessively vibrating state, to dismount from the ...

...a front or top load?  Either can be off balance, but, front loaders have more of  a tendancy due to the load falling from the top when the drum slows down or stops in prep starting ...

...The door bellow DOES wear out with age, but if you have a tendancy to overload the washer it can contribute to premature wear. If you determine that the ...

...on front load washers, I don't think any of the will get away from a mold problem. they all have a tendancy to hold some water in the door gasket and some of the lower insides. Most all of the front ...

...The door bellow DOES wear out with age, but if you have a tendancy to overload the washer it can contribute to premature wear. If you determine that the ...