Makita Tools 12" Compound Miter Saw - LS1221 "problems" Questions

troubleshooting chicago 7" tile saw wont turn on. turned it off for a few minutes, then it wouldn't turn back on. problem power switch brushes worn problem armature circuit breaker for power point

miter saw has stopped working. i have checked the plug and electrical connection. it worked without problems 2 days ago. it gave no warning of problems. is there "a built in" fuse or circuit breaker

My saw was received with the saw blade not tracking parallel to bottom guide. It appears to be shipping damage. Is there an adjustment to correct this problem? I noticed your post after I just posted ...

Electric brake Fault. Blade Runs On. I have the the same fault, but have seen a differance since a new set of brushes were fitted. It has not cured the problem completly but it has improved. some of ...

Ryobi compound miter saw stopped working, smoked a bit, and blew a fuse. Now it turns on, laser works, but does nothhing when you hold the trigger down. What now? Could be one of the field coils have ...

I just bough a new dewalt 12" compound slide miter saw... And the bolt that holds the upper part of the saw to the deck and allows the saw to rotate/angle is too loose ... I've takin the plastic ...

I have a makita dual slide compound miter saw model number LS1016L and when I lock it in on the positive stops I can't get it to release to change the miter angle. What part needs to be ...

MODEL# TS1352 LASER LIGHT NOT WORKING WHERE ARE THE BATTERIES AND THE LIGHT LOCATED. BLADE GUARD DOES NOT GO UP OR DOWN HOW DO I ADJUST Russell- The operators manual is available online at: Manual ...

I have a Hitachi C8FB2 compound miter saw that the electrical break has stopped working on. The bushings are still good but I see and hear a electrical arc were the bushings touch the shaft. What can ...

not cutting a straight line anymore. positive stop is at zero. If I put a 4" board on the saw to cut, I will end up 1/16 to 1/8 inch outside my line at one end. I recently replaced the blade and ...