Question about Boating
mercury outboard 70 hp 1987 when in forward gear the prop turns one way when in neutrel spins both ways when in reverse the prop is locked both ways is my lower unit working property when is lower ...
...mercury two cycle boat motor 2005 Take The Propeller Off, Use The Rear Thrust Washer As a Tool Turn It Upside Down And Put It Back On The Prop Shaft The Three Slots Should Match With Bearing ...
...turn at all when turning in reverse (or be resistant as your back spinning the water pump -don't do that) Once in gear (forward ) you should be able to mate the shift to the motor. I have removed ...
...mercury 150 hp outboard into gear it hits really hard. Why ? It happens in forward and reverse. See if you can turn down the base idle some. Then check your gear lube, sometimes you can get an ...
...mercury. i t turned out to be a bent propeller shaft it could also be a bent prop pull it out of the water and spin it. also push and pull on the prop and see if the berings are loose hope this helps ...
mercury 115. Goes forward fine, but grinds in reverse. The prop turns, but only slowly even if you idle up. This could me that reverse gear is not fully engaged.Adjustment on the cables is needed.Take
mercury 50 blueband and i cant get it in gear can you help thanks If you are trying to shift it while not running the "shift dog" may not be lined up with the gear, turn the prop a little should go in
...mercury mariner 60 hp. i don't have a diagram Its not too bad to adjust, just takes patience and an assistant would be nice. You want to center the linkage in neutral so the throttle does not move ...
...mercury 90 elpto starts and idles ok, will rev in neutral but won't rev in gear in the water. It bogs down with some surging. i HAD THIS ISSUE SERVERAL YEARS AGO , TURNED OUT THAT THE PROP WAS ...
530 questions posted
Usually answered in minutes!
78 Questions
