Hobart AM14C-155 Dishwasher "120 heat problems" Questions

...heat the water up to 120 degrees. it will heat a degree a minute. depending on what the temp is in the washer. try turning on the hot water first before you turn the dishwasher on. verify that the ...

...did not get warm, put unit on heat dry and and test voltage at the element. 120 volts present replace element. if not check voltage at thermal fuse for 120 volts. If no voltage there replace

...120 degrees. However, with the Water Heat option selected it does not appear that the water is heated. When opening the door after the cycle has started, the water level is below the heating element ...

...seems ok, you have to test the controller to see if it is powering the element (probably should be 120

...by Ohming it out to check for continuity, Control board: to check to see if the heater is getting 120 volts to it in Heated dry cycle. Do you use Jet Dry or any Rinse Aid? I always advice consumers ...

...120 volts if not the problem is in the control. If it does have power and does not heat up replace the element. The heating elements is easy to replace. Timer/ Control This is not as common as the ...

...120 volts if not the problem is in the control. If it does have power and does not heat up replace the element. The heating element is easy to replace Timer/ Control This is not as common as the ...

heat the water up to 120 degrees upon each fill cycle. This is not optimal and it adds much time to the already long full cycle. When you run the hot water at the kitchen sink until it is hot and then

...the "manual" the most likely problem is your water is not hot enough. Water temp should be between 120 and 140 degrees. Also, I would NOT use gel detergents since they have a reputations for not ...

...heat the water to temp. However it has a 3 hr default if it doesn't reach temp. Start the cycle and see if after 1 hour if the water is hot or cold. If hot, then it is heating the water and the water ...