Jura Capresso Impressa E75 Espresso & Coffee Maker "apart grind brew" Questions

...coffee and old grinds are expressed directly into to bottom bin. I have taken the front of the unit apart to see what's going on, and it appears there is a hose disconnected. I would like to find a ...

...a way to reset the burrs so they are closer together as they used to be fine. I took the grinder apart and found to have to replace the two metal grinding tools (inside cone and outside ring. The ...

apart, clean and lubricate the brew unit here: http://www.buessert.de/Technik/Jura-IMPRESSA-S95/Cleaning.htm ...but they are not for the faint hearted. There is also a cheats way too which I use. 

...grind and brew. The grinder whirrs like it's grinding, but the hopper is not vibrating to let the beans go down in there. I've taken the top part apart and unstopped the grinder, but still no luck. ...

...grind, message says "checkbrew unit" and ground beans have been dumped straight into waste container. What I have done: Cleaned and greased, several times. Taken brew unit apart, cleaned again and ...

...grind cycle, even after cleaning the grinder and grounds chute in the grinding mechanism. my dgb 550 is doing the same thing. the motor shaft is stripped and i'm going to pull it apart and use ...

...grind and brew and when we put water in the resevoir, it immediately leaks all over the counter. we've taken it apart and put it back together, read the instructions, are we missing a seal? any tips? ...

Grind and Brew has begun leaking water underneath the unit as it is brewing. I also have the same problem with water leaking out of the bottom.There is a defective hose underneat the burner plate (dry

...grind and start. After I do that it brews a full pot. We have cleaned well and still does the shut off after a small amount is brewed. Dave Our Cuisinart won't finish brewing the coffee. It stops ...

...apart, and cleaned out what looked like old compacted beans, thinking for sure that was the problem, but they're still not coming through.Could the motor have burned out? - I'm trying to fix this for ...