Kenmore 6000 BTU Single Room Air Conditioner "highest conditioner runs" Questions

Ad

runs perfectly normal when I turn it on for about five minutes then it stops blowing cool air and I can hear that the compressor isn't running anymore. Even when I turn the temperature dial to highest

Ad

Question about Mitsubishi Heating & Cooling

1 Answer

...I have two 17000 btu units (500 sq ft rooms) to one compressor (30) I have it in the cool mode, highest fan speed and vane set straight out. They are running and running and running. It is

Ad

Question about Haier Heating & Cooling

1 Answer

...conditioner trying to fix haier HWR24VC5 need to know what color wire goes to which post on compastor On the Compressor? - Theres a run (R) that gets the red wire from the run capacitor or line side ...

...to see if it turns freely, Place fan on highest speed try to spin by hand on highest speed , if it works you may need a new capacitor for fan motor if not try and jumper fan switch to see if it runs

Question about Mitsubishi Heating & Cooling

1 Answer

...the evaporator coil and make sure it is clear of all dust and debris. run the t stat up to the highest setting and see if the heat cuts off

Question about Kenmore Heating & Cooling

1 Answer

...turn it back on but turn it on at a higher temperature. Then ease it to the lowest temperature or highest cool setting. You probably have a clogged filter in the front of the a/c unit which takes

...conditioner 20000 btu's was purchased in 2004. I have less than 1000 square foot house and this unit has previously cooled the entire house but has not done so this season. It is blowing air properly ...

Question about Dometic Heating & Cooling

1 Answer

...winding resistance from common to start start to run run to common the two lowest should equil the highest also check shorted to ground check the capacitors the go bad a ...

Question about Fedders Heating & Cooling

1 Answer

...runs even when turned off No matter what I set it on the compressor never goes off even if I have it set to fan only or have it set of 88 degrees.. It will ice up behind the filter so I unplug it. ...

...the Unit ) will shut the unit off. Try running the Unit on a lower speed and sett the stat at the

Not finding what you are looking for?
Heating & Cooling Logo

13 questions posted

Ask a Question

Usually answered in minutes!

Top Kenmore Heating & Cooling Experts

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Kenmore Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...