...treadmill you have a short-circuit on your 20N60 transistor. replace this transistor and your DCMD67 circuit board will be new! but be careful, if this happen on your circuit board, In about 90% you ...
Question about Tunturi Exercise & Fitness
...treadmill circuit board? I have been trying to find a supplier for a Tunturi T85 treadmill circuit board. The manufacturer recommended distributor in Canada hasn't answered their phone in a ...
...repairing in the circuit board of treadmill should done by an experienced person in it, because there are harmful high voltage areas in the circuit board. Consult some one who is experienced in it. ...
Question about Nordic Track Exercise & Fitness
...circuit board Treadmill was working fine then next day no power/display or lights of any kind. Took motor cover off and circuit board has a red blinking light whenever power is plugged in. 1( tight ...
Question about Exercise & Fitness
...circuit boards are in the t7000 treadmill and the c7000 bike c7000 upright commercial exercise bike and the t7000 commercial treadmill from Johnson Fitness Dear Sir:The circuit boards, are generic ...
...treadmill motor controlling card is igbt fault. igbt will be fitted on the heatsink replace the same. also check the related driver transistors in its gate rail. instead of motor u can connect a bulb ...
Question about Proform Exercise & Fitness
...treadmill goes full speed on power up Typically when this occurs, it is an indication of a short circuit in the motor controller board. To test to make sure the problem is in the board 1) Unplug the ...
Question about Bowflex Exercise & Fitness
...treadmill Calibration fail. Next indicated action? Once powered up, the motor runs for a second or two and stops. Cannot turn the power switch off, must turn off at main bottom power switch. Speed ...
...treadmill from wall outlet. Wait 60 seconds, allowing lower board to discharge built-up energy.Remove motor cover.Verify that there are no lights lit on the lower circuit board.Verify that all wires ...
...treadmill from wall outlet. Wait 60 seconds, allowing lower board to discharge built-up energy.Remove motor cover.Verify that there are no lights lit on the lower circuit board.Verify that all wires ...
351 questions posted
Usually answered in minutes!
96 Questions
46 Questions
44 Questions
26 Questions
37 Questions