Question about DCS Cooktops
...knob to go off The light on the control knob stays on in the off position, when the light stays on the clicking continues. Only when I slightly turn the the control knob towards the "Hi" position is ...
...knob was turned off. Sounds like a short in that particular burner circuit. Usually when the light stays on even after cool down the heat sensor is bad. This is inside the burner. If your getting ...
Question about Gaggenau Cooktops
light when the starter knob is depressed and turned, but as soon as I let go of the knob, the flame goes out. I have to hold it down for a count of fifteen before I can let go of the knob and have the
dcs igniters igniters keep clicking they stop when front burner lights other burners will work but clicking wont stop clean the knob control by using vaccium,pull the knobs then clean it.make sure how
...knob is cracked and/or loose. If all the burners do this then it is just the way the cooktop works. The best way to get the burners to light is by slowly turning them on until they light and not pay ...
...knob is "off") the RR burner doesn't light. In order to light the RR burner, I have to turn RF knob to "spark" and simultaneously turn on RR burner. The unit is 3 yrs old and the RR burner has always ...
...light with a lighter. Also I have found that I can push down the knob on another burner (#2) and the burner on #1 will ignite (when I push and turn #1), so its not a problem at the burner but at the ...
...back. Look over the LED light modules which shine just below each knob and fashion a replacement LED assembly. Total material cost per LED unit was ~ $2-3 (LED, resistor, wire and heat-shrink
light under the knob is on all the time. Also, not all burners are heating sufficiently. What to do? The switch under that knob is bad. It's called an infinite switch. As far as the elements go, first
11 questions posted
Usually answered in minutes!
32 Questions
14 Questions
18 Questions
12 Questions