Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum "vacuum hose problems" Questions

...hose and it's too bad, because the vacuum works well, but trying to use the hose attachment it futile because it just doesn't stretch out unless the vacuum is pinned up against something to keep it ...

vacuum hose. does anyone know its whereabouts? Cleaning brushes don't rotate during cleaning! It might be a clogged vacuum hose. Does anyone know its whereabouts? I would advise you to ALWAYS to FIRST

hose off, turn the vacuum on and see if there is good suction at the vacuum where you attach the hose. If there is good suction at the vacuum there is either a clog in the hose or if it is an old hose

...areas of suction loss are within the hose itself, the vacuum bag, clogged rollers, broken vacuum belt or a faulty gasket. All of these problems will lead directly to the vacuum cleaner losing

...hose and into the vacuum. If the suction is good when the hose is out, the the problem is blockage at the bottom piece. Take the cover off of the rollers (it is one screw then it pops right off) and ...

...vacuum hose could be clogged , the filter could be dirty, or the bag is too full ? run a marble or steel ball thru the hose to see if there is any blockage, by doing that you can tell where the clog ...

...vacuum cleaner. I don't have the problem with the beater bar, but I had the problem with the attachment hose not getting any suction. I found out that I was putting attachment on the wrong end of the ...

...not the hose placement help Hi, Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem. Bissell Proheat Upright Wet/Dry Vacuum Problems heatman101 ...

...2 large dogs and no vacuum :) There is a vacuum hose that attaches inside the unit to a round clear plactic piece. In most cases you can simply cut the small vacuum hose and it will fix the

Vacuum hose problem I have a Bosch BSA2100uc-02. The vacuum still works great, but the hose from the vacuum to wand handle has a hole in it. I would like to replace just the hose with plastic ends ...