...motor will help identify the correct carbon brush, however new brushes will NOT always solve your problem if the motor is arcing. If the armature is worn like an apple core or if the lines between ...
Question about Bissell Vacuums
...motor brush. The motor brush is a small, spring-loaded carbon block that makes contact with the motor to conduct electricity. If the motor brush falls out or is not installed correctly, it can cause ...
...brush motor will not engage until the power is turned on and the handle is in the down position. In the upright position the brush motor wont engage. Typical faults will be the belt is broken and ...
Question about Vacuums
brush motor to replace it with a new one. I removed the washer & e-Ring from the motor axle but I can't remove the gear. Thanks!!! May be a burned out collector of the armaturebetween the brush holder
...motor brush source? Our power nozzle motor is dying. I cleaned it and that improved the situation, but one of the carbon motor brushes is badly warn and I'm sure that's what's causing the problem. ...
...motor has simply worn to the point where a brush has stuck or worn to nothing, you may be bale to reseat the new brushes, however any evidednce of BLUE sparks or noise is not a good sign . Best of ...
...motor from running. You can check the condition of the brushes by removing the brush holder and inspecting the brushes. If the brushes appear to be worn down, they will need to be replaced. Another ...
Brush motor check? So brush doesnt spin. Belt good, roller is clean, can I check voltage when the head is off? Continuity measures? A broken drive belt, damaged brush roll, jammed brush roll bearings,
...is bad. My miele does the same after a few minutes. I have now deduced that the brush rollers stop because the motor gets hot. The suction part is fine. So why is this brush roller motor
Question about Bissell Vacuums
installed brush I get no resistance. I had one melt the plastic around the bearings on the brush. you might try taking out the brush first, getting to the motor you'll have to take it completely apart
16 questions posted
Usually answered in minutes!
126 Questions
14 Questions
6 Questions
13 Questions
4 Questions