Kenmore 63793 Convection / Microwave Oven "without anything inside" Questions

...inside the microwave; I would suggest giving it a good clean and attempting to use it again without anything inside to see if its still sparking; otherwise I would say you should get a new

...on and makes a loud zapping noise. There is no metal inside and have tried without anything inside. Sensor error message comes on immediately. Worked fine up until now. Hi! try checking the

without anything inside, however, it is dead. No power indicated. Unit doesn't have its own circuit. No breakers were thrown. ???? may have poped the fuses inside it,, but there not the normal type of

...without the rack)? Thanks. The problem that you are having is that the magnetron inside the microwave is shorting out to ground and it will find the shortest path to reach whatever has metal in it. ...

...without anything inside. Microwave was set to high and on for three minutes. Damage to top inside door. Plastic melted right through with two holes. Also burnt just below that. Inside top frame also ...

a Kenmore over the range microwave. My kids turned it on without anything inside. Is this repairable and worth it or just buy a new one I recommend a new one because the magnetron has been compromised

...anything this normaly just happens it just stops heating its most likley to be the magnatron thats the part that heats the food up,,,it just gives up the gost,,,normaly without warning too, there are ...

...without setting it to run. I removed the cover over the carousel motor and didn't see anything unusual. Oddly when I turned the microwave on either side, the carousel motor did not run when the door ...

...without anything inside. Now the unit doesn't work. What could be wrong and is it worth fixing? Might just be a fuse, probably worth repairing. Could be the magnetron in which case you'll want to ...

...without risk of damaging anything. The safety switch is in the door latch mechanism. Just make sure you pay attention to how the door is assembled and reassemble it so the door seals properly when ...