...But no brewing coffee, no water. Remove the brew unit and check the screen under the red o-ring, find the 2 screws above the top piston and make sure the chamber that leads out to the tube is
Question about Saeco Coffee Makers & Espresso Machines
...brew unit after a jam? Brew unit was jammed in Magic De Luxe, had to disassemble brew unit to extract it from machine. Now drive axle will turn 1+ full revolution when unit is powered on. Brew unit ...
...unit getting jammed. Some of the most common problems are : Split ?O? Ring on Brewing Unit Faulty Coffee Brewing Unit Twisted ?O? Ring on Brewing Unit Beans In Decaff Chute Split White Cog In Brewing ...
Question about Saeco Coffee Makers & Espresso Machines
...brew unit. The brew unit can't compress the coffee and jams the brew unit which breaks the drive gears. Drive gears have to be replaced. I have some drive units complete. Hello, ...
Question about Gaggia Coffee Makers & Espresso Machines
...brew unit blocked" appeared this morning, but didn't reappear after I emptied the dreg drawer and removed, then replaced the brew unit. Any Thoughts? Brad First clean the screen and tube on the brew ...
...brew unit I tried replacing the brew unit O ring with a non-standard part and now it is jammed and I can't remove it. I ran the machine again using a plastic card to activate the micro switch for the ...
...brew unit. As the brew unit moves up and down, you'll see the piston being guided. Rince with water 1st. Use a silicon spray that dries clear. not that white sticky stuff. It just collects coffee ...
Question about Saeco Coffee Makers & Espresso Machines
...brew unit to the center. Line up the 2 diamonds and it centered) If you look down through the funnel you should see a piston. This should be centered in the funnel. If not, locate the slide on the ...
...brew unit missing there is actually a brew unit present switch. that could be your problem. either that or a bad electronic. hope you got like 800 dollars to throw on a 3000 unit. The brew unit ...
...is on and blinking and see if the brew unit will cycle. The drip tray has to be in for this to work. There is a metal bar that has to be pushed toward the rear of the machine to cycle the brew
169 questions posted
Usually answered in minutes!
440 Questions
417 Questions
393 Questions
348 Questions
266 Questions