...back into place. The brew group is out of place. The brew group cannot be taken out. Turn on the machine and close the service door. The brew group will automatically go back into place. The brew ...
...back in order The most important thing is to keep the service door shut, and all the parts, ground basket, drip tray etc. in place. The mechanical will only operate with these things in place. Hope ...
...back in, but it will not 'reset' after switching off / on. Can you help please? Regards, Neil Hi Neil, Try to put the dregsbox and driptray on place, close the door and turn on the machine. When the ...
Question about Krups Coffee Makers & Espresso Machines
...door back on, but I have a metal spring clip and can't figure out exactly where it fits on the basket door/body of the coffee maker. can you help? yhere should be a little post th spring goes on in ...
Question about DeLonghi Coffee Makers & Espresso Machines
...back panel by removing the two screws sliding it upward slightly then pulling it out. Then remove the two screws holding the side panel in place(the side that the door hinge is on). Slide the panel ...
Question about Saeco Coffee Makers & Espresso Machines
back into place Yesterday, I removed my brew group for cleaning as I have in the past. I left it to thoroughly dry overnight. In the morning, the brew group would not slide into place. I don't want to
Question about Cuisinart Coffee Makers & Espresso Machines
...back on the door its self is fine There is a plastic gasket that sits inverted on the upper side of the basket. Place the gasket open side down above hole. Place the spring on the pin and push it ...
Question about Saeco Coffee Makers & Espresso Machines
...are tightly in place and check the door sensors ( the magnetic sensors may need replacing). Also, consider trying to completely power off the machine, wait a few minutes, and start it back
Question about Saeco Coffee Makers & Espresso Machines
...and push it back into place but more than likely you will have to pull the guts out of the body and put it back in. If its there then you might have a power filter that is bad, again inside the
place it on the bottom left side of the brew unit, then with 2 fingers reach up inside the bottom and grab the bar in the center and squeeze the bar to the left. This will bring the cylinder back into
414 questions posted
Usually answered in minutes!
440 Questions
417 Questions
393 Questions
266 Questions
176 Questions