Question about KitchenAid Refrigerators
...ice dispenser mechanism to repair/replace it? remove the bottom tray that you sit your glass on, push down on the bottom of the trim arround the despenser, lift outward then upward on the trim panel, ...
Question about Whirlpool Refrigerators
...replace the ice guide clear plastic cover over the ice shute on the outside of the freezer door? I have a Whirlpool side by side refrigerator model ED5FHEXS00. order the chute assy old pull out and ...
...ice thru the door , is not closing completely . This will cause frost on the upper portion of the shoot AND cause frost on the inside of the dispensor where it covers the shoot . Replace the flap ( ...
Question about KitchenAid Refrigerators
...ice dispenser mechanism to repair/replace it? Hi DonaldG. Are you sure it is something blocking the ice from falling? You might want to check this, There is a troubleshoot section for ice problems, ...
Question about Kenmore Refrigerators
...ice maker and freezes in the fill chute?? If yes, than replace the water valve. If not then: does the flap shut all the way? Sounds like you are drawing moisture from the chute. The flapper should ...
ice chute frosts up?? This is caused by a rusted plunger and solenoid . To replace them ( in a kit pt # WR62X10055 ) , remove the top plastic hinge cover of the freezer door , and disconnect the plug ...
...the ice and water is bad. Snap the cover off the front and then you will see 4 screws holding the housing in place. Remove this and you will see the solenoid. Replace this and you will be good to
...ice chute door at the bottom of the chute keeps opening and closing on its own. I can't get it to stop. I unplug it, but when I plug it back in, after a few minutes is starts all over again. The ...
...it to make contact depending on the gauge you used then replace the ice maker motor module if you hear the valve open and the ice maker doesnt fill check for a frozen ice fill tube that should do ...
Question about GE Refrigerators
...but mine closes immediately when the lever is let go from getting ice. Does that have anything to do with the condensation? Thank you for any help you can give me. replace flap they wear after ...
1,409 questions posted
Usually answered in minutes!
332 Questions
312 Questions
169 Questions
102 Questions
105 Questions