...100, the Heat up cycle "clicks" as normal, but the oven does not heat up. Checked both the broil and the bake elements and both measure "0" ohms, with my cheap ohm meter, and neither are shorted to ...
Question about Jenn-Air Kitchen Ranges
oven operation, however, overshoots set point 75-100 degrees during convection How do you know? Are you using a thermometer to calibrate? clean temperature probes(sensors) usually found in oven center
...fan assisted type ovens have a safety that keeps th fan off if it believes the door is open. Look for uneven door closing or cracks in the door to frame closure. Is this a commercial convection
...The broiler works. The oven is less than 5 years old. The convection and roast options are not working either. You need a new control panel circuit board. Easy to replace. Search ...
Question about Blodgett Kitchen Ranges
...convection oven with LP. Oven stopped lighting. The blower still works when turned on and doors closed, but checked ignitor and it does not get red to light burners. Wondering if the ignitor bad, ...
Question about Frigidaire Kitchen Ranges
...oven only heats up to 100 degrees. Please help? Contact a technician. The ignition and gas valves should allow the unit to preheat and then reach needed temperature within about 30 minutes, at the ...
convection oven is not heating up. It is stuck at 100 and the display is moving between preheat and bake. I had the same problem and I replaced initor (part number 492431). It is working now. It takes
...100. I've tried "bake" and "convect", and neither one work. "Clean" doesn't work either. The oven will lock, and display shows that it's heating up, but temp. never rises. However....."broil" feature ...
fan will not run blodgett dfg-100 Check the door switch located inside the front lower panel. If the door switch is operating correctly, check the motor run capacitor inside the control panel. Until ...
Question about Blodgett Kitchen Ranges
...100 fan motor sometimes only works on low speed Oven sometimes only works on low fan. Any suggestions as to the cause? May not be moving enough air to cool elements allowing motor to over heat try ...
402 questions posted
Usually answered in minutes!
192 Questions
105 Questions
116 Questions
75 Questions
64 Questions