Siemens 20Amp 1-pole arc-fault circuit breaker "breaker trips lights" Questions

...breaker keeps trips without load The Lights circuit breaker keeps trips without any load. Overnight the circuit trips. The circuit works OK for a while but either during the night when the lights are ...

...breaker trips in my bedroom when ever a load is put on line. The trunk line comes into a three gang switch box and feeds the entire room. At times I can turn my ceiling fan and light on for 10 to 20 ...

breaker trips sporadically I have a new home (constructed 3 yrs ago) that has an arc fault breaker that runs the guest bathroom and one bedroom. Almost never use the guest bath and the bedroom has had

...breaker trips when you turn florescent and can lights on Sounds like something is wrong with the light check the wiring. Unhook the light and try ther breaker if breaker does not trip then problem is ...

...breaker, but the switch, the wires in the box, or the lights, or something along the line, you will have to check each one. New construction has made all lights and all receptacles separate, so if ...

...lights seem to trip the breaker each time they are plugged in with one or more sets. Suggestions? My out side lights keep blowing the breaker even if we use different breakers for different stings ...

...trips the other arc fault breaker on that phase.These arc fault breakers will not trip unless there is a load.This is a older house and the only outlets affecting these arc faults is on the new sub ...

...lights upstaires circuit breaker keeps tripping was ok yesterday but now keeps tripping out Jan 2013 1) Move wire to another same-size circuit breaker to eliminate bad circuit breaker as suspect. Do ...

...trips the breaker to pin point what is causing the short. If the above has no effect, I recommend replacing the breaker. It is easy and inexpensive to do. Just make sure you main is shut off before ...

breaker trips when the light switch is turned from "off" to "on". Try connecting using the screws on the side of the device instead. more then likely you were not going all the way to the off position