...power is restored the switch will not transfer back and the generator cuts off leaving the building without power. Sounds like a problem with the H-100 controller. Contact Generac to get
...by lifting the float switch? Is your switch attached or plugged in to your pump? I believe your on your model it is hard-wired. If so, bring it back to the retailer/wholesaler from whom you bought
Question about Intermatic Electrical Supplies
...switch i just turn off, and turn it back on when its time. I recently replaced hunter solenoid, hoping that was help with the issue but didn't work. Thanks in advance for your help, 1) ...
Question about Zoeller Electrical Supplies
...switch. If you can get into the lower part where the pump sucks the water in, then see if you can get it to turn the opposite direction.(screwdriver) Probably a stone holding it back. Make sure power ...
Question about Zoeller Electrical Supplies
...switch arm, but will not trip it to turn on the pump. If I barely bump or touch the arm manually, the pump kicks on and pumps water just fine. Ugh. Me too! I keeps setting off my back up pump with ...
Question about liftmaster Electrical Supplies
Our door is automatically reversign itself. It goes down and pops back up. Hi, The adjustment is wrong...either there is something on the floor that it is hitting...frost has pushed up the floor a bit
Question about liftmaster Electrical Supplies
sensor light orange and door won't stay closed when run automatically Hi, If you are in a cold climate the ground may have pushed from freezing and then the door hitss to hard and will go back up... ...
...doesn't work, put switch back in and see if lights turn on that way >>> it could be a loose wire suddenly cropped up Last step >>> timer is no good, you need another one. We
...switch won't stay turned on We have two relay light switches that are used on the same lights in our kitchen. They turn on if we keep our fingers pressed on them, but as soon as we let go they ...
generator available light rapid flashing ge zenith ztx-rm series will not transfer back to utility press the reset key(button) on the controller (asumming you have a R-M4 controller.) The R-M3 ...
689 questions posted
Usually answered in minutes!
627 Questions
549 Questions
166 Questions
208 Questions
109 Questions