Question about Parmak Electrical Supplies
I have a Parmak Model DF-SP-LI. With a volt meter it reads 2.3 on the fence, but the performance meter is always reading beyond the green. It depends on the type of fence tester. the common ...
Question about Parmak Electrical Supplies
I can hear the charger clicking but the meter is not reading check voltage coming from unit with a FENCE voltmeter if voltage is in the5to6000v range probabley the meter is faulty youdoit.com you need
...read a full charge on the se-82-6 charging a lead acid battery The battery is fully charged when the gauge reads zero. If you look at the meter, the charge meter of 100% is slightly above ...
12 Volt Battery charger How do you test the diodes? To test a diode, use an ohm meter. Place the red lead from the ohm meter to the anode, "Positive" end of the diode, and the negative lead to the ...
...should give you a reading, depending on the state of the battery. To do a quick test on the charger, try it across a headlamp bulb, The bulb should light and the amp meter should read about 5
Question about Schumacher Electrical Supplies
...read the meter. As the needle goes upward, it seems to indicate a lower percent charge but more amps. I.e., when it's charging 6 amps, it looks like it has zero percent charge. It's a SE 82-6 charger ...
READ THE METER ON SE-82-6...RED AND GREEN TRIANGLES...DON'T KNOW WHICH DIRECTION THE NMEEDLE'S SUPPOSED TO BE GOING. The meter is telling you approximately how much current (amps) it is sending to the
Question about Schumacher Electrical Supplies
...read the guage,when do i know battery is fully chargrd or battery wont charge?se-82-6 When the amp meter reads 0, then it is no longer drawing amps and is fully charged. i hope this was helpful, ...
...V 5) Charger on at 50A position Battery Voltage = 15.93 V At any of these positions, the charger Ammeter always reads zero. It never gives a reading other than zero. The meter gives a little "bip" ...
Question about Siemens Electrical Supplies
...our home and I have checked the wiring going into the breaker, it is as shown on the package. Volt meter shows a reading of 113.1 volts on the neutral from the breaker. The neutral from the circuit ...
166 questions posted
Usually answered in minutes!
627 Questions
549 Questions
535 Questions
166 Questions
208 Questions