Siemens Seimens Arc Fault Breaker "trips under" Questions

What causes a transformer 12 volt dc for under counter lights to keep tripping the resent button? Check to make sure the wattage on the bulbs is correct, If correct, there may be a short causing the ...

Switch will not turn on disposal The switch will not turn on the disposal. under the sink you will probably find an electrical outlet with the disposal cord plugged in. If so, plug another item into ...

t104 intermatic was replaced but will not turn on Previous t104 timer was not working. Replaced with a new t104 and ran wires the same way but still will not power on. Your wiring is incorrect -or- ...

I have a problem getting the timer to supply 220 Volt?. I get 110Volt. I have a 30Amp breaker and a double pole breaker and 310 wire. Where am I going wrong. Should the white wire from the plug go to ...

remote will open door when remote is hit to close door the light flashes and will not close. The wall unit will close door but the button must be held and released when the door hits the floor. Make ...

breaker popped and wont reset yellow light on arc fault breaker after plugging in small humidifier unplugged but it wont reset Hi, I don't know if this has been solved or not, but anytime these G.F.I.

have b/r/w coming in....b/w go to old duplex outlet...black from outlet to switch..red direct to light switch...want to replace duplex with gfci and add a two switch device, one switch controlling ...

...trips again something is lodged in the unit and you must clear it out. Turn the power off at the service panel before attempting this. It may also be getting power from a GFCI receptacle. Check the ...

Will not drain...but is turning....i tried to reset by pushing the red button and did nothing...i took the L wrench and turned it from the bottom and still nothing...sink is full of water too..what ...

...under any circumstances replace the AFCI with a standard circuit breaker or GFCI type circuit breaker. You may however, change it with an adjacent AFCI breaker to determine if the issue is with the ...