...motor running? First, turn off the power to the disposal at the circuit breaker. Do not put your hand in until you do this. If you hear the motor running, but not the blades, then the blades are ...
Question about Ace Hardware Electrical Supplies
...disposal. I used the reset button and the motor will run but the blades are not turning. Also when the diswasher is draining, water comes up through the garbage disposal is that normal? sound's like ...
...disposal seems to be running the food is not being chopped up. I don't think it is correct but the blades seem to be stuck in place, with the motor on they spin but do not pivot. Any Ideas??? If the ...
Question about Ace Hardware Electrical Supplies
...disposal blades rotate freely, but disposal will not respond, then disposal needs to be replaced. Check for power at disposal. If blades rotate, and allen wrench works fine, then the bearings are not ...
...Motor will over heat and begin to fail.Now. Put your shop vac hose down into disposal if your suspect broken glass or other hard to remove stuff.Then get a wood broomstick and put down into disposal ...
...disposal turns on, but the blades are not rotating. It sounds like the motor is not turning over. Use wood stick or broom handle and see if blades rotate freely. If blades are stuck, then use wood ...
...disposal not working. Motor hums, blades are not rotating. I can rotate the service wrench with tension. I would keep working the impeller back and forth with wrench while running hot water thru ...
...If wrench turned freely from the beginning and motor still hums. Replace disposal. I hope this has answered your question, please rate how helpful the answer was. Good Luck and Have a great
...motor will not start then disposal has gone bad. 2) If disposal cutter disc is still stuck, then you might be able to salvage by removing two nuts on p-trap below sink. P-trap drops free. Remove 2 ...
Question about Ace Hardware Electrical Supplies
...motor overheats leading to failure. 3) Once disposal is loose from sink, you can grab fabric with vice grips, and carve with a chisel and screwdriver to reduce the amount of fabric. And finally use ...
734 questions posted
Usually answered in minutes!
3 Questions
1 Questions
2 Questions
