...new blade because the original one's I ordered a new blade because the original one's scew part inside broke & the blade wouldn't screw on. However, the new blade's screw in partis to ...
...the thumb). This will remove the blade Select the blade you want to use Put the new blade in back, then push down on the front of the blade, you should hear a snap, and the new blade will be in
with a vacuum cleaner, The new blade will come pre-lubricated in the driving slot but the blade will need periodic oiling. You need to remove the blade to properly lubricate the back edge of the blade
them. No problem look at your clipper blade, you will see 3 screws remove the screw in the middle ONLY, The clipper blade will come off, replace with new blade put back the middle screw on and tighten
new blades are not the answer try replacing the blade drive assembly which is located at the drive end of the clipper and goes from side to side, as the clippers are used this part will gradually wear
adjusted for more power and speed, also what clipper blade are you using to cut the horse hair and how long is the horse hair, Also the blade may not be sharp, some new blade are sharp maybe defective
...new blades and the cost of them. Careful, blades may not be dull,most of the time it is the blade alignment that needs correcting even on used blades, been cutting and repairing clippers for over ...
Replaced with new blades, and now not cutting I just replaced the Styliner II blades with new ones, screwed it on and now i's not cutting at all The protective film is still on the blades.( spray with
need new blades if you need new blades u should go to a place.... i forgot what it was called but they can put new blades on them my huby had that problem as well
...new blade latch with the same results. It again appears that the latch dodent extend up enough to engage the latching point on the clipper blade. I've followed the instructions on blade ...
195 questions posted
Usually answered in minutes!
113 Questions
15 Questions
17 Questions
11 Questions
14 Questions