2-3? Try this: You can reset the control by unplugging the blower during start up, leave unplugged for at least 5 seconds, plug back in and within 30 seconds cycle temp control from hot to low 6 times
Question about Water Water Heaters
...unplug the unit. Open the unit being careful of fragile electrical wires. Next remove the computer board and then disconnect each plug in wire and reseat them one at a time. Reassemble the unit and ...
Question about Water Water Heaters
john wood water heater stuck in vacation mode cleaned igniter pushed red and green buttons nothing happening Try unplugging it plug it back in and see if it resets
...unplug heater and plug back in. Immediately press two temperature buttons. Wait for green light to blink. Release buttons. Page 34 in troubleshoot chart. 5) Take a moment and rate answer: And take ...
...reset on the outlet, there may be a leak inside it. GFI's usually only trip in the presence of water creating a path to ground. It could be just starting to leak and shutting off before enough comes ...
Question about General Electric Water Heaters
...Unplug system, wait 1 minute, plug back and see if it clears. You may have had a power outage. If so reset settings on control. here is the link to manual. ...
...reset until the paint fully dries and it doesn't have any "vapor" left to sense. You can try unplugging the unit and leaving it unplugged for a few minutes and then plug it back in. This is ...
My Rheem 41VRP50N does not start , red light flashing , but gas does not start. I unplugged it and plugged back but no luck , how to reset it , any help welcome You need to know the code for resetting
...unplug unit, then remove face panel and they will be labeled, hooked on 2 small phillips head screws, replace panel and plug back in) your unit should still (more often than not) kick on and heat to ...
320 questions posted
Usually answered in minutes!
335 Questions
250 Questions
222 Questions
190 Questions
96 Questions