Reliance Water Heater #6-30-YORT 30GAL NAT GasWTR Heater "replace lights control knobs" Questions

...control knob Defective thermocoupleCheck and replace thermocouple Defective safety magnet assemblyCheck and replace gas valve Pilot burner orifice cloggedClean or replace Pilot tube pinched or ...

a few seconds until the thermocouple heats up. Release the button. Twist the gas control knob to the ON position, and the burner should fire up after a few seconds. Replace the access cover. Good luck

the control is bad the tank is probably not far behind (changing the control could cause it to leak). Unless the water heater is less than 3-5 years old, replace the whole thing! Please rate my answer

pilot light won't stay lit when I release pilot knob. getting 4 flashes on controller Have replaced the pilot assembly. no model told , not even makers name. but modern have a flame sensor ,bad. it ...

...heater won't fire. Pilot light is on. Gas valve is White Rodgers 37c73u 238. Is 37c73u 168 a direct replacement? With pilot light on, and turning control knob from max cold to max hot, it will not ...

Blow out goo after and re-install fitting and try again. If that doesn"t work, replace gas control. P.S. Highly recommend certified experienced tech perform this control valve replacement if necessary

...replace? works OK & no gas smell. The gas control is leaking gas around the knob? The gas control needs to be replaced before causing explosion and/or fire. Gas control has identifying marks on ...

...replace the thermocouple? Could be thermocouple. Might also be lack of air supply, or low gas pressure, or bad gas control valve, or tripped FV system due to lack of air supply: ...

...lights but doesn't stay lite. I have also replace the thermocouple. Now I orginially thought it was the control valve, but when exchanged it did the very same thing. I am wondering being Lp would the ...

...control valve? Troubleshoot and resources on following links: http://waterheatertimer.org/How-to-light-gas-water-heater.html ...