Bosch AquaStar 125FXKIT-NG 125FX Natural Gas Tankless Water Heater w/ Hood "pilot light not stay" Questions

pilot light has gone out. get a long stick match, a flashlight remove lower inspection cover, find thermocouple and pilot light will be next to it,turn gas valve to pilot light and hold down,stick the

pilot light will not stay lit. More than likely the thermal couple is defective. The thermal couple is a safety device that shuts the gas off if the pilot goes out. If it is defective the pilot light ...

pilot light will not stay Lowe's hot water heater pilot light will not stay lit Hi, If it is one of the new ones with the fancy gas control and the blinking light... does the light blink?? or not?

Pilot Light problem Pilot won't stay lite. Banging on the controller and couple of time and re-lighting the pilot is the only way the pilot stays lite and goes thru the heating process. Replace themo ...

...Pilot-light-will-not-stay-lit.pdf http://waterheatertimer.org/pdf/Pilot-outage-troubleshooting.pdf http://waterheatertimer.org/pdf/Vent-spillage-test-atmospheric-gas-water-heater.pdf ...

...pilot light is not staying lit. You light the pilot and water in the tank reaches temperature. Once hot water is gone, then pilot light has to be lit again. Gas pressure is good, and gas is flowing. ...

...pilot will light, then you have gas. If pilot goes out when pilot button is released, then thermocouple is next suspect.Thermocouple tip must sit in pilot flame.The pilot light heat applied to two ...

pilot light will not stay on Bosch natural gas tankless water hea Bosch Tankless water heater Pilot light on an 8-10 year old unit. About every 3-4 months the pilot light will go out. Today, when this

...pilot light on hot water heaters is controlled by a thermocouple, a small copper rod that usually sits in or very close to the pilot light flame. When they go bad, which is not unusual, they do not ...

pilot light will not stay lit. I can light it, but when I release the button for lighting, flame goes out. Pilot won't stay lit and won't transition to burners Check the pilot thermocouple. You may be