Sunbeam 2350 Heritage Series Mixer "remove beater mix" Questions

...up to where it connects in to the mixer and hold for about minute. Once the hot water has melted the build up you should be able to remove the beater. Hopefully this may work on your brand of

Remove the bowl, and beater and lay the mixer on its back. You should be able to see under the head a screw sticking out, it does not have a head, but a little slot in the screw, use a flat head screw

Mixing head How do you tip the mixing head back to remove the bowl and beaters? Slide the locking lever toward the rear and lift up the head.

beater too low in the bowl and therefore won't mix. (I tried to whip up some whipping cream but it pushes the whipper down too hard on the bottom of the bowl. It turns but it's not pretty) Get

...may correct from home using a flathead screwdriver. Unplug the mixer, with the bowl and flat beater removed. Tilt the mixing head back as far as the machine will allow. In the exposed hinge, behind ...

beater doesn't rotate Remove the metalic ring around the mixing head. Push down on it with a flat head screwdriver... Remove the pin from the mix shaft. Pull down on the mixer head. Inspect the gears.

...remove splash shield, tilt mixer back,with a long screwdriver adj. the set screwclockwise to decrease clearance for beater to bowl clearance,always use b beater when making adj. clearance should be ...

...beater attachment spins but will not spin or mix when dough etc... are placed inside the bowl. Is this a transmission problem? Or a shaft bearing? Can someone please help me diagnose the problem. Is ...

...beater. If you remove metal, be sure to do it in a balanced fashion to avoid unwanted vibration in the beater. If you're not up to removing metal, take it to a machine shop and they'll do it for you. ...

...remove and re-insert the beaters. Then plug it back in and try it. If not, it might be the motor. These are very inexpensive($12 on amazon) and are known for problems. I would plan on buying another ...