Question about RVs

Open Question

1996 terry 30 g 110 volt power out thru floor but no lites or plug ins work is there a junction box or what ?

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

110 volt a c wiring diagram for a 1996 terry travel trailer model 30 g


http://more119.gorumanuals.com/terry-travel-trailer-owners-manual-1996-moperpv.pdf

Dec 08, 2016 | RVs

2 Answers

Outlets not working all fuses are good


120-
VOLT
AC
SYSTEM
The following electrical components (if so equipped) will only operate when your
RV is connected to shore power: 120 to
12-volt power converter, air conditioner,
120-volt refrigerator, microwave oven, television(s), fireplace and appliances
plugged into convenience receptacles.

SECTION 6 - ELECTRICAL SYSTEM JAYCO TOWABLE
6-2
120-
VOLT
CIRCUIT
BREAKERS
The 120-volt AC circuit breakers located in
side the main load center protect all
120-volt wiring and components in the RV fr
om circuit overloads and short circuits.
Should a circuit overload or short circui
t occur the circuit breaker protecting the
affected circuit will "trip" preventing the flow of electricity through that circuit.
If a circuit breaker trips, shut "off"
the appliance on that circuit (i.e., power
converter etc.) and allow the circuit breaker to cool down for a brief period of time.
After the cooling down period, reset the circuit breaker by moving its lever "off" and
then back to the "on" position. If the circuit breaker re-trips or frequently trips,
contact your dealer to have the electrical problem diagnosed and repaired.
A circuit breaker identification label is permanently attached to the inside surface
of the 120-volt load center.
Maintenance and Replacement
At the beginning of camping season, inspect the circuit breakers and replace as
needed. Test by turning each circuit breaker "off" and back "on". Circuit breakers
are wearable parts and must be replaced
as needed, as part of your RV
maintenance. If you have any questions, consult your dealer.
Please contact your dealer for repair assistance when replacing circuit breakers.
CONVERTER
The power converter converts 120-volt AC power to useable 12-volt DC power
when the shore power cord is connected to an external power source.
The converter has a built-in protective thermal breaker that will shut it down should
overheating occur. Overheating can be
caused by operating the converter above
its maximum power output for an extended period of time, or by an obstruction to
its ventilation air flow. To reduce converter heat build keep unnecessary 12-volt
lights and motors turned "off"
.
Keep the converter cooling fins and fan clear of
obstructions.
Inspection and maintenance
If the 12-volt power converter is not working (auxiliary battery not being charged)
check the reverse polarity fuse(s) in the converter fuse panel.
There are no
customer serviceable parts inside the converter case and the
manufacturer's warranty will be void if
the case has been removed
. If you
have further concerns contact your dealer.

Nov 16, 2014 | Jayco 2013 Jay Flight Swift 264BH

2 Answers

Can anyone provide me with an Owners Manual for a 2001 - 33.5 feet, 5th Wheel, EX park model, Terry RV, built by Fleetwood


The coach will have a very generic manual then each appliance/component will have a different manual. The AC will have a manual produced by its manufacturer and the same for the refrigerator, water heater, furnace, etc. To obtain those manuals to will have to find the manufacturer, model and serial number of each item then go to the manufacturer website to their support area and download.

Oct 09, 2014 | RVs

1 Answer

Wiring diagram keystone laredo 296rl


RV manufactures do not publish wiring diagrams. Are you trying to install a ceiling fan or trying to determine the circuit that it is located on?

Jun 09, 2014 | Keystone 2013 Laredo Super Lite 296RL

1 Answer

What needs replaced on 2011 evergreen ever-lite 25RG travel trailor after submerged in river water up to floor for 12 hours


Depends on the construction of the floor. If it is the composite floor that is a layer of luan, Styrofoam and luan. Then the entire floor will need to be replaced. Heavy moisture will cause the glue to release and the floor will fail. The walls may also cause an issue if the water permeated them causing the insulation to get wet. Mold will begin to grow and could cause heath problems down the road.

May 19, 2014 | Evergreen 2011 Ever-Lite 25 RB

1 Answer

Slide and Awning Electric problems


i have seen a meter lie, it shows a good circuit, but when a load is applied the circuit breaks, try a test light to see if the breakers hold

Apr 07, 2014 | Heartland 2014 North Trail Focus Edition...

1 Answer

Running lights


Brake lights and running lights are on different wires with power being supplied through the 7pin connector between the tow vehicle and the trailer. Under the tongue there is usually a junction box that the "pigtail" is wire through and the lights are wired in at that location.

Apr 05, 2014 | Keystone 2010 Hideout 26B

1 Answer

Wiring schematic


There should be a junction box located outside under the floor and will have a "pigtail" wire going from it to inside the frame of the coach. Beyond that you have to trace the wiring as there aren't any published wiring diagrams.

Mar 14, 2014 | Dutchmen 2012 Denali 289RK

Not finding what you are looking for?
RVs Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top RVs Experts

Ken Strite
Ken Strite

Level 2 Expert

69 Answers

Rich Lewis

Level 2 Expert

78 Answers

keylempi

Level 1 Expert

38 Answers

Are you a RVs Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...