Power gear slide out go out is ok, but on retrac the moteur running all time to slide is close.

You need to get under the unit. There is a bolt and nut that sheared and the shaft that moves the unit in and out is turning without the bolt and nut in place. This commonly occurs when the slide out has not been greased and it has been squealing for some time. If you could just get the slide even on both sides and then align the shaft hole with the rod and then install th bolt and nut you will complete the repair. Also, underneath you will possibly find the sheared bolt and nut , it usually falls out when you remove the rubber chassis cover to expose the shaft turning rod, good luck...

possibly gear arm is bent. slide outs are not made to be sat and lived in. you should be able manually slide it in. try to lift slide out by the arm with a hydraulic jack. place jack on ground use a 2x4 or 4x4 between jack and gear arm and lift gently. the teeth on arm could be stripped also. just ease into it..

there is a gear under the slide some units have a hole to slide the wrench "provided" in it and turn the crank when it starts moving if you have 2 holes on it most do you will have to move it in equally

Contact your local service center directly or online here:

Slide buttons don't work - on retrac slideto close the mother run all time.

Every slide out has a manual override for the motors. You should be able to call the dealer you purchased it from and they will tell you where it is. You can then adjust it back to a closed position and use it normally.

On the opposite side of the coach from the slide you need to manually close. You should see a hole through the frame. You should have also received a crank handle that has what seems to be a piece of pipe with a notch cut into it. Inside the referenced hole you should see a shaft with a roll pin through it. Insert the crank handle until it is seated on the shaft with the roll pin then begin to crank until the slide is retracted.

You will need to determine the manufacturer of the slide mechanism, the diameter and number of teeth on the gear. Once you have all of the information you should be able to order a replacement gear from your local RV parts department. To replace you will need the unit on level, solid ground. Place a good jack close to where the gear is located. The purpose of the jack is to support the slide while the gear is out. Do not try raise the slide more than is necessary to remove the gear. Remove the bolts holding the gear and remove the gear pack. You may need to use pry bars to assist. If so, use a block of wood against the floor of the slide to pry against. Reverse the procedure to install new gear and ensure the timing of the slide mechanism does not jump.

check fuse for power then wiring for power to motor then check motor for operation then gear or pully system and slides for a seized condition

Contact your local retailer/service center directly or online here:

Contact Winnebago Industries Call Mail or Visit Winnebago