Where is water pump located on this unit - Keystone 2008 Montana Mountaineer Edition 285RLD

Question edited for clarity.
Question moved from Cars and Trucks.

2003 Jayco Designer Pump location? - Jayco RV Owners Forum

https://www.jaycoowners.com > forums > 2003-jayco-d...
Jun 21, 2020 - The water pump is accessed from the bottom rear of the Designer. Remove the ABS belly pan and there is the pump. Be prepared to have a helper.
Designer Water Pump Strainer
Sep 22, 2017
Water Pump Location
May 9, 2016
water pump
Sep 16, 2013
Water pump location?
Oct 10, 2018
More results from www.jaycoowners.com

In most travel trailers, the water pump is typically located underneath the trailer, near the fresh water tank. The exact location may vary depending on the specific make and model of your trailer.
To locate the water pump, you will likely need to access the underside of the trailer by crawling under it or using a jack to lift it up. Once you are underneath the trailer, look for the fresh water tank and follow the water lines from the tank to the pump.
If you are unable to locate the water pump or are unsure of its exact location, you may want to consult the manual for your specific model of North Trail 22RBK travel trailer or contact the manufacturer or a qualified technician for assistance.
I hope this information is helpful. Let me know if you have any other questions or if there is anything else I can assist with.

if separate fill holes then bad check valve at water pump

look for a removable access panel, typically near water in line on ext of unit

One way to locate the water pump is to turn on a facet and then turn on the water pump. You should be able to hear it run as it tries to "catch up" on water flow/pressure. Look where the sound comes from. You can find the water heater from outside the RV by looking at the walls for a access door that has a screen on a portion of it. This will be the location of either the water pump or the furnace. If furnace, look for another such door.

some tanks don't have drains ,just slant it to the pump end and pump it out

If the trailer has a fresh water holding tank it will have a pump. The older units have a hand pump located next to the sink. There should be a switch located inside the camper, typically on the monitor panel. When you turn that switch on and open the faucet you should hear a vibration noise. If the switch does not illuminate that could be that the circuit is dead and the fuses will need to be checked. The pump is usually located near the sink behind an access panel that will be screwed shut.

Make sure the winterizing valve for the pump is not open. Locate the pump. On the input side of the pump there may be a valve in that line with a line coming from the tank and the other line laying loose not connected to anything. Turn that valve to close the open ended line which will then allow it to draw out of the fresh water tank. This would also raise a serious question as to how well the trailer was inspected during the pre-delivery inspection process...

They usually locate them close to the kitchen or bathroom sinks. Often times they will be hidden behind a concealment panel in the storage space under the bathroom. You will have to possibly remove your items in storage behind the kingpin. On the drivers side of the unit inside the storage space there should be a carpeted panel that will have four screws holding it in place. Remove that panel and behind the "docking station" where all of the fresh water supply connects you should find the fresh water pump.