Vuka XL 125 - Recent Questions, Troubleshooting & Support

0helpful
2answers

How do I get at the solenoid in my Vuka model XR125 ?

Need to change the solenoid(starter relay)
11/7/2016 8:23:25 AM • 2010 Vuka XL 125 • Answered on Nov 07, 2016
0answers
0helpful
1answer

Vuka scooter not starting

Check fuel, Maybe a fuse..
10/9/2014 12:53:38 PM • Vuka XL 125... • Answered on Oct 09, 2014
0helpful
2answers

How do I adjust my golf carburettor to be more lean and less rich?

On the carb there is a little adjustment screw. inward reduces the fuel consumption.
7/4/2014 5:29:30 PM • 2010 Vuka XL 125 • Answered on Jul 04, 2014
0helpful
1answer

Valve clearence for VukaXs125 2007

inlet 0.10 exhaust 0.10mm
5/24/2014 3:20:05 PM • 2010 Vuka XL 125 • Answered on May 24, 2014
0helpful
1answer

Valve clearence

inlet0.08 exhaust 0.10mm
5/24/2014 3:19:04 PM • 2010 Vuka XL 125 • Answered on May 24, 2014
0helpful
1answer

Removing the rear wheel

Make sure the axle is all the way out and the rear brake adjuster is loosened a bit and the rear brake rod disconnected. You may also need to pull off the chain adjusters; sometimes they function as an additional safety device to keep the axle from wandering off.
2/26/2014 7:11:51 PM • 2010 Vuka XL 125 • Answered on Feb 26, 2014
0helpful
1answer

My hmc green machine 3000ss weed wacker carb needs adjusting it only runs with choke closed

Try cleaning or changing the air filter. If it dirty the engine will not stay running with out the choke on.
2/17/2014 3:21:06 PM • 2010 Vuka XL 125 • Answered on Feb 17, 2014
0helpful
1answer

Vuka 125cc when you press the start button. It

check your valves it must be around 0.10 mm
2/17/2014 7:24:41 AM • 2010 Vuka XL 125 • Answered on Feb 17, 2014
0helpful
1answer

Hey plz tel me why my xl110 dies on me every +- 1km wen i ride.then i hav2 runstart it again 2 reach my destination.i kick myself blue in da face bt no help.wen i just idle da bike;after a few minutes

Sounds like the gas tank isn't venting. If air isn't allowed to enter the gas tank to replace the gas flowing out, vapor lock happens. Next time it dies, remove gas cap and see if it starts quicker/easier, and runs longer. If so, then you have a plugged vent.
1/16/2014 11:17:12 PM • 2010 Vuka XL 125 • Answered on Jan 16, 2014
0helpful
1answer

Wat are the speks on a vuka 125 floud level

0.75mm
9/23/2013 5:21:39 PM • 2010 Vuka XL 125 • Answered on Sep 23, 2013
0helpful
1answer

Where do i throw my

your engin and gearbox oil is in the engin
6/24/2013 2:52:07 PM • 2010 Vuka XL 125 • Answered on Jun 24, 2013
0helpful
1answer

Vuka xt250 indicators stop working.

it could be the switch or the indecator unit
6/24/2013 2:46:22 PM • 2010 Vuka XL 125 • Answered on Jun 24, 2013
0helpful
1answer

Chain?

more info what about your chain?
6/23/2013 9:01:43 AM • 2010 Vuka XL 125 • Answered on Jun 23, 2013
0helpful
1answer

Oil for vuka xl110

you can use any 20w50
6/23/2013 8:51:12 AM • 2010 Vuka XL 125 • Answered on Jun 23, 2013
0helpful
1answer

Hi my vuka has a red light flassing and looks like a shelphone not always

more info please
1/26/2013 5:06:11 PM • Vuka XL 125... • Answered on Jan 26, 2013
0helpful
1answer

I have a xl 110 vuka and it seems like it is loosing some power when i have traveld for more then 10 miles. also seems like a bit of over heating

your xl 110 motor an gearbox is in one 20w50 sould do the trick just check your oil level at the small glas
1/26/2013 4:47:38 PM • 2010 Vuka XL 125 • Answered on Jan 26, 2013
0helpful
1answer

The headlights are dim on one side on my chevy pickup

Make sure you have the rite bulb, check you voltage level at the pigtail and compare to the other side if those are fine check you ground wires if voltage is low inspect power wires for corosion or broken wires Also check the resistance if no obvious damage to wire but resistance is high the wire should be replaced
10/15/2012 11:01:18 PM • 2010 Vuka XL 125 • Answered on Oct 15, 2012
0helpful
1answer

Vuka XL 110 What is correct setting for air mixture screw on carburetor?

wined the air mixture screw all the way in and then 2 and a half turns out then start the bike if it will let you (no choke) if it wont start turn another .5 turn until it will start.Once you get it started leave it running at idle and listen to the engine noise very carefully. give it a rev and even a ride if it stalls wined it out .25 of a turn.
6/13/2012 12:09:04 PM • Vuka XL 125... • Answered on Jun 13, 2012
0helpful
1answer

My brother vuka xl 110 there is a small hole on the head .wish I can post a picture also to say what I am taking about .I want to know will oil spill out the hole that is in the casing of the head .

Yes, It will leak oil. How much will depend where the hole is. When the engine is running the oil is a pressurised system so it won't be supplying enough oil the the moving parts of the engine. Take a photo with your phone and there is a button on the bottom of the comment box. Use that to add photos. As a general rule If the cylinder head has ANY damage like holes and cracks Replace it. A cylinder head is cheaper than a replacement engine or a bike.
3/2/2024 1:19:06 PM • Vuka Motorcycles • Answered on Mar 02, 2024
Not finding what you are looking for?
Motorcycles Logo

Popular Products:

19 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Vuka Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66821 Answers

Larry Ng
Larry Ng

Level 3 Expert

14548 Answers

Are you a Vuka Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Vuka Motorcycles

  • Forum

View Most Popular

  • Vuka Motorcycles
Loading...