Question about 2003 Harley Davidson FXDL Dyna Low Rider

1 Answer

How do I deactivate the immobiliser on my 2003 Harley FXDL as it is really irritating with the constant alternate indicator flashing each time you touch the bike & having to fiddle about pressing the little button on the remote three times before you start the engine.Would rather not have it at all .Many thanks

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Harley Davidson Expert
  • 438 Answers

Is it possible just to remove the fuse to disable it?

Posted on Jan 03, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 2336 Answers

SOURCE: Starter dragging problem

You added an extra ground but did nothing with the positive cable. It's time to replace that one, possibly using better quality cable then stock.

Posted on Nov 20, 2008

  • 29 Answers

SOURCE: Starter dragging problem

Two things come to mind, other than an internal problem with the starter. Diconnect the battery and take the small cover off the solenoid. pull the plunger and spring out and check the 2 internal contacts and the copper washer on the plunger for a badly burned or worn condition. Rebuild kits are available for some models. If not, you can dress up the contacts and the washer. Push the plunger in by hand and see that it hits both contacts at the same time.
Another possibility is the starter clutch. Usually when these fail the starter spins without turning the engine over, but I have seen them cause the symptom you described. Replacement involves removing the starter and dissasembly of the drive end of the starter, but since you were savvy enough to take the initial steps you mentioned, I know you can handle it.

Posted on Dec 25, 2008

stephensaon_
  • 284 Answers

SOURCE: Electrical ( & engine ) shut down Harley

Make sure that you have the updated wire loom installed for the ignition switch. There was an additional relay installed because of overheating. That would also cause you bike to die. Pull the fairing and check for burnt wires. but also check to make sure that there is an additional harness attached to the ignition switch, between the ignition switch and the harness going to the rear of the bike ( on the right side of the frame towards to top.

Posted on Aug 27, 2009

wd4ity
  • 4565 Answers

SOURCE: 2003 Harley Davidson XL 1200 C Sportster Custom

I would guess stale gasoline or fuel. Try fresh fuel in the tank. If this doesn't clear the problem, you could need to have your carburetor or fuel injection system cleaned. I'm not even sure if they put fuel injection on Sportsters since I don't work on fuel injected bikes. I mostly work on the older bikes like Panheads, Shovelheads, Evos. Not too many Sportsters but have worked on a lot of Ironhead Sportsters. Try the fuel first. It's a cheap fix. Hope it works for you. Good luck with the knee replacement. My wife had one knee replaced and it works great.

Posted on Dec 15, 2009

  • 653 Answers

SOURCE: my bike will not start, securty system activated,

Do you have the alarm installation manual, check in there if you have to get a sequence else disconnect the power for 15 minutes to make immobiliser released and re-install

Posted on Mar 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is the wiring different on a 2001 fxdl from a fxdw


Sorry I cannot help at this time but if you go to an H-D dealership a shop foreman may be able to help OR it may be a fairly cheap solution to just but a service manual.

May 20, 2014 | 2002 Harley Davidson FXDL Dyna Low Rider

1 Answer

I have a 2000 dyna fxdl and the rear blinker is lighted all the time and dose not flash and when u hit brake light it acts like a brake light and the left front blinker wont flash


Hi Anonymous, check your wiring and connections from the turn signal switch to the turn signal module with a testlite. Make sure all connector pins are corroded, broken, or loose. For a free wiring diagram please visit the website below:
Good luck
Harley Davidson Wiring Diagrams and Schematics

Feb 05, 2014 | 2000 Harley Davidson FXDL Dyna Low Rider

1 Answer

Remove rear fender harley fxdl 2003


Hi Anonymous, I'm sorry you can't find the very first and best tool you ever bought for your Harley Davidson. Despair not, for a mere $6.50 you may be able to download another one from the website below and good luck. Harley Davidson Manuals Mark Workshop

Jan 19, 2014 | 2003 Harley Davidson FXDL Dyna Low Rider

1 Answer

Siolnoid reoplacement 2003 fxdl harley


Hi Anonymous, perform the following tests:
1. Fill acid type batteries to proper levels.
2. Charge battery overnight at 1-2 amps you need 12 volts or better after charging.
3. Make sure all connections are clean and tight especially the negative cable at both ends.
4. Hook up volt meter to battery and start engine, if meter falls below 9.5 v replace battery.
5. With engine running at 3600 RPM battery should read 14.3-14.7 volts if not continue tests.
6. Unplug voltage regulator from alternator at crankcase by front of primary cover.
7. To test voltage regulator go to: https://www.youtube.com/watch?v=F8EjV0IjW9Q
8. With ohm meter, one lead grounded, touch alternator pin meter should read infinity, if not replace stator.
9. With ohm meter, both leads touching alternator pins meter should read 0.1 to 0.2 ohms on 1989 and later models. 0.2 to 0.4 ohms 1988 and earlier models, if not replace stator.
10. With volt meter set on AC scale, both leads touching alternator pins meter should read
16 to 20 volts AC for every 1000 RPM'S 1989 and later and 19 to 26 volts AC for every 1000 RPMS. If not replace rotor. Good luck

Dec 18, 2013 | 2004 Harley Davidson FXSTS - FXSTSI...

1 Answer

Change oil on my 2002 fxdl lowrider 2002


Hi Anonymous, for more information about your question please visit the websites below. Good luck and have nice day.
DIY Oil Change on 2003 Harley Davidson Dyna

Aug 28, 2012 | 2005 Harley Davidson FXDL - FXDLI Dyna Low...

1 Answer

Change transmission fluid 2003 fxdl dyna low rider


Hi Anonymous, for more information about your question please visit the website below. Good luck and have nice day.
Harley Davidson Transmission Oil Chage

Jul 26, 2012 | 2003 Harley Davidson FXDL Dyna Low Rider

1 Answer

How do you deactivate security alarm on a 2008 Harley Davidson FXDL?


Hi Anonymous, for more information about your question please visit the website below. Good luck and have nice day.
Set Change Override Transport Harley Security Alarm PIN Code No Key Fob...

Jul 10, 2012 | 2008 Harley Davidson FXDL Dyna Low Rider

2 Answers

Where is the connector for the indicator lights on 2003 fxdl?


Hi Jpierrot, check underneath your instrument housing. Have nice day.

Jan 18, 2011 | 2003 Harley Davidson FXDL Dyna Low Rider

1 Answer

My battery died on my 2003 tiburon and i tried to boost it and the lights start blinking and the siren goes off but the car won't start


Hello there,

Your Immobiliser has activated the alarm, you must deactivate the immobiliser to deactivate the alarm. go into the car (even if siren is wailing and your neighbours are nosy) close the door and put key in the ignition, turn key to ACC position. Hold down unlock button till you see indicators flash once. Remove keys and get out of the vehicle. Try unlocking and locking. This should be reset.

Cheers Buckaroo,
Chris.

Apr 19, 2010 | 2003 Hyundai Tiburon

1 Answer

I have replaced the battery and it will not hold a charge. The motor sounds like it is not firing right and when it idles the LED mileage indicator flashes on and off. After I let it run for a period of...


Harley's won't run without a battery.If the battery is going south the engine will run like **** till it dies.If the alt./regulater/stator isn't working the battery will soon discharge just running the motor.All the other goofy stuff like the led is becauseof the battery.It won't hold a charge because there is no charge.Start with regulater/stator

Mar 21, 2010 | 2003 Harley Davidson FXDL Dyna Low Rider

Not finding what you are looking for?
2003 Harley Davidson FXDL Dyna Low Rider Logo

197 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Mike

Level 3 Expert

4339 Answers

yadayada
yadayada

Level 3 Expert

76070 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...