Question about Honda Motorcycles

Open Question

Rear wheel of my honda activa bought in june 2010 is stuck and not rotating at all. this is just after a successful drive of about 6 kms just before it happened. please let me know what cud be the problem. now it doesnt rotate at all. the engine starts normally but wheel does not budge.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 599 Answers

SOURCE: '90 civic won't start.....bad disributor????

wont rotate?..go to battery and starter circuitry

Posted on Nov 09, 2008

rainstreet
  • 1 Answer

SOURCE: MY FORD EXPLORER WONT START

fuel pump relay

Posted on Dec 17, 2008

  • 58 Answers

SOURCE: Rear end noise from front wheel drive car

At that mileage it could be, and most likely is given your description of the noise. I assume it reduces in volume as you slow down. If you can find a quite piece of road drive up to where the noise is apparent and lightly swerve from left to right. (Don't roll the car!! ) If the noise reduces as you swerve left then its the left bearing. If its when you swerve right that the noise reduces its the right bearing. If its both the only way is to jack the rear up and spin the wheels as fast as you can and listen. If there's a hint of a rumble from it, its that bearing or both. It should be completely quite apart from the slight hiss as the shoes rub on the drum.
35K may not seem much but if you don't know the history of the car it could have hit a bad pot hole or even had a knock on a kerb.
I have replaced bearing with a lot less miles than yours.

Cheers John

Posted on Dec 17, 2008

  • 112 Answers

SOURCE: how to use reserve in honda activa

Has it got a reserve ?
Look at the fuel tap.

Posted on Jan 19, 2009

  • 86 Answers

SOURCE: rear wheel drive on mower does not engage

Its possible that the cable slipped does the pulley turn on top of trans.if so does the shaft turn if so then your gears on wheels need cleaned or replaced.

Posted on May 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 Honda Activa turn signal fuse location


Hi, Manu for this scenario you will need your service/owners manual if you can't find the best tool you ever bought for your Yamaha, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
2007 Honda Activa turn signal fuse location Google Search
Fix scooter that does not have working turn signals
http://www.family-motorsports.net/GY6-50cc-150cc.pdf
http://www.partsfish.com/page/oem-parts-for-honda
Honda activa 2009 Owner Manual

May 27, 2017 | 2005 Honda Activa

2 Answers

How can I remove Activas front mudguard?


Hi, Arsalaan for more information about your question and valuable "FREE" downloads that you will need please visit the websites below. Good luck and have a nice day.
http://campaigns.hondampe.com.au/Motorcycles/manuals/SCV100%20LEAD.pdf
Honda Activa Top 10 Service Tips
Milaege Solution For Honda Activa
How to replace wheel bearings Honda Activa part 1


Mar 14, 2016 | Motorcycles

1 Answer

Rincon. Why is there grinding noise in rear end and rear wheels will not drive?


Could be bad u-joints, wheel bearings. Raise rear of vehicle and rotate wheel by hand, if noisy remove and replace. Hope that helps.

Dec 18, 2015 | Honda Cars & Trucks

1 Answer

Honda activa 2010 model wheel nut size?


Hi, Anonymous the answer to this question is way above my pay grade for this situation, I would call or visit my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
rear wheel nut size
FRONT WHEEL OF HONDA ACTIVA 110CM9
http://www.family-motorsports.net/GY6-50cc-150cc.pdf
http://www.partsfish.com/page/oem-parts-for-honda
Honda activa 2009 Owner Manual

Feb 05, 2015 | Honda Motorcycles

1 Answer

Honda activa 2005 front wheel bearing size pls


Bearing number of Honda Activa for any model is 6004 for Rear Wheel and 6201 for front wheel. I get it replaced recently. SKF are good bearing you can use as spare. I did not cost more. 10 Jan 2015. it

Jul 09, 2013 | Motorcycles

1 Answer

I hv activa for 2006 model,my daily travel is almost 50 kms perday - 6days in a week, from last 6 months Activa started giving starting problem and last week white smoke started coming out while drivi


White smoke is classic head gasket problems in water cooled engines ... Your engine is air cooled but you can still have top end troubles. I suggest you have your motorcycle checked by a professional before you ride much more. info on your ride here: http://www.honda2wheelersindia.com/activa/specifications.html

Dec 03, 2012 | 2005 Honda Activa

1 Answer

I can't get rear wheel to slide back on the gear


Put the motorcycle in gear so when you rotate the rear wheel the spline on the final drive does not rotate with the wheel. Did you remember to grease the final drive spline with Moly60 Paste available from your local Honda dealer?

Jun 17, 2011 | 2004 Yamaha V Star 1100 Classic

1 Answer

My 2010 honda cr v with 5000 miles went in for maintance. Oil change and tires rotated. Now my steering wheel is tilted to the left and when I straighten it the car veers right. Honda says the alignment...


I am a Honda Master tech. There is no such problem for this vehicle. First things first, if the vehicle drives straight , but the steering wheel is off center, then that's what the problem is...the steering wheel is not centered. when an alignment is done to a vehicle the steering wheel is set be a technician (not by a machine). My advice to you is to take it back to the dealer and go for a road test with the service manager or shop foreman. show them what you mean. they will take care of you. good luck

Jan 20, 2011 | 2010 Honda CR-V

1 Answer

How frequently we should change the engine oil of honda activa.


change oil each 500 kms and the oil filter each 2nd time.

Aug 03, 2010 | 2005 Honda Activa

1 Answer

Vibration and noise from front end while driving


Jack up the front end and put stands under it and block rear wheels. Look at axle boots and see if they are cracked. Try turning wheel back and forth sharply and see if you can hear any clicking. Problem could be outer axle joints. If the boots are cracked or you hear a clicking noise you will have to replace the axle. The axle and boot come as a complete unit. Please let me know what you find out.

Apr 13, 2009 | 2002 Chevrolet Venture Passanger

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...